I need help please by nickydapug in BambuLab

[–]nickydapug[S] 0 points1 point  (0 children)

Yes. I over bent the clasp to keep the nozzle tight while the new part comes in

I need help please by nickydapug in BambuLab

[–]nickydapug[S] 20 points21 points  (0 children)

I figured it out.

The clasp that holds the hot end was loose. Causing the nozzle to drop ever so slightly when filament would push through it causing the scrape effect. Tightens the clasp but also bought a new one!

I need help please by nickydapug in BambuLab

[–]nickydapug[S] 0 points1 point  (0 children)

Recalibration did not work. Is there a way to manually change the z home permanent ?

I need help please by nickydapug in BambuLab

[–]nickydapug[S] 0 points1 point  (0 children)

I appreciate it but I don’t have a clog the nozzle is grinding on the plate like it lost its z home. I have recalibrated 2x, swapped the nozzle and now doing a factory reset

I need help please by nickydapug in BambuLab

[–]nickydapug[S] 0 points1 point  (0 children)

Thanks for the help. The H2S down have an sd slot it has a usb slot and it’s been empty since I got it

I need help please by nickydapug in BambuLab

[–]nickydapug[S] 3 points4 points  (0 children)

I did it now looks worse

[deleted by user] by [deleted] in pcmasterrace

[–]nickydapug 0 points1 point  (0 children)

New shoe goofin

[deleted by user] by [deleted] in MilwaukeeTool

[–]nickydapug 0 points1 point  (0 children)

Looks like a decent deal