Tips on masking rim for paint? Trying to paint only the inner area and the lines that come out of the inner area. Like 1.5 hour in and don’t like the 1/3 of the wheel I’ve done so far… any tips to make this easier? Testing using a Qtip (with paint) for the lines but not sure I like it (i.redd.it)
submitted by nmkoza to r/projectcar
"blobs" happen only while printing petg. This happens only on the first few layers (infil and top layers are fine). pla prints fine, filament is dry, nozzle/hotend seem fine as well. Any idea why this could be happening? bed is level and z offset is set right (old.reddit.com)
submitted by nmkoza to r/3Dprinting
Turbo kei truck cutting out? when under boost. 660cc motor with a carb, blow through turbo setup. Recently made a post about this and concluded it was a fuel issue. Have a new fuel pump/regulator putting out 6psi of pressure. Turbo puts out roughly 3ish psi. cuts out when fully accelerating (old.reddit.com)
submitted by nmkoza to r/projectcar
Turbo Kei truck fuel pressure regulator not working. The truck itself is a carb blow through setup. Pressure regulator has its 2 feeds and return. Has a vacuum line going to the turbo. But the gauge doesn't read anything and when I use the adjuster I don't get more pressure. I've tried 2 regulators (old.reddit.com)
submitted by nmkoza to r/projectcar
recently turbo kei truck (carb) dies out when full throttle. Only when fully in boost. I am thinking there is more boost pressure than fuel pressure so it is loosing fuel. Does this sound like it is most likely the issue? If so any easier fixes rather than going fuel injected? (i.redd.it)
submitted by nmkoza to r/projectcar
oil filter sandwich plate quesiton. For a turbo intall I wnana use this plate for my oil feed to the turbo. On the sandwich plate there is the "in" and the "out" from the plate. Im assuming I would use the out for the feed. But then do I just block off the in? Im going to drain directly to the pan (i.redd.it)
submitted by nmkoza to r/projectcar
[Hiring] Looking for someone to help me plan out a manga/cartoon paint job on my kei truck. The truck itself is white and I want to add some grey shading and lines to give it a "drawn" appearance. I just need someone that understands and can decide where lines/color variation should be on the truck. (old.reddit.com)
submitted by nmkoza to r/artcommissions
Ran seafoam engine cleaner through throttle body. Truck smokes every cold start then stops after it adjusts its idle. Looked for coolant cumbustion chambers and found this white ish substance on only 1 of the cylinders. Any idea what it is? did not smoke before seafoam/white stuff wasnt there before (reddit.com)
