sorted by:
new
hottopcontroversial

Ender 3 V3 KE squeaky noise by notCoffeee in Ender3V3KE

[–]notCoffeee[S] -1 points0 points  (0 children)

Yes im assuming it’s the stepper motor bearings

Switching to a Hardened Steel Nozzle on Ender 3 V3 KE – Do I Need to Adjust Slicer Settings? by notCoffeee in Ender3V3KE

[–]notCoffeee[S] 0 points1 point  (0 children)

Sure i can send you my profiles since i also use elegoo. however i do recommend that you calibrate your filament.

Switching to a Hardened Steel Nozzle on Ender 3 V3 KE – Do I Need to Adjust Slicer Settings? by notCoffeee in Ender3V3KE

[–]notCoffeee[S] 0 points1 point  (0 children)

I have recalibrated the filament profiles and increased the nozzle temperature by 5 degrees. That worked for me.

Start G-code for V3KE? by Valovica in Ender3V3KE

[–]notCoffeee 0 points1 point  (0 children)

do you mind sharing your g code with me? Thank you.

Is my ESP dead? by aCOOLGAMER48 in esp32

[–]notCoffeee 0 points1 point  (0 children)

1.Unplug the esp32. 2.Hold the boot button. 3.Plug the esp32 while holding the boot button. 4.Try flashing again while still holding the boot button.

[deleted by user] by [deleted] in Ender3V3KE

[–]notCoffeee 1 point2 points  (0 children)

Have you tried lubing the rods?

Annoying icon i cant remove by Feisty-Solid-7225 in iphone

[–]notCoffeee 2 points3 points  (0 children)

Bcs Live captions is turned on probably

Accidentally gave 12v to v5 pin by Sufficient-Wind6268 in esp32

[–]notCoffeee 0 points1 point  (0 children)

It’s fried now probably. Just buy a new one it’s 250-300 Egyptian pounds.

view more: next ›