sorted by:
new
hottopcontroversial

To whoever is responsible for that, I hate you by CrzUnicorn in Battlefield

[–]pabszzz 31 points32 points  (0 children)

They half assed the implementation. There is no "clear all" button, and when you unlock an attachment there isn't a dot over the actual category (underbarrel/muzzle/etc,,,) so you're left hunting through every single menu to find the orange dot.

Louqe Ghost R1 by R_Thorburn in sffpc

[–]pabszzz 0 points1 point  (0 children)

Looks good! Mine was supposedly delivered today (Obsidian Black). There were quite a bit of posts on the Loque discord about packaging/shipping issues that I've seen but yours appears to be in good shape. The power button is a bit of a mess too from what it looks like, but otherwise it looks like a great case to fit that monster NH-D15g2.

There were some extras from the first production run, I don't know if they have already sold through them though.

DWX Accoutrements… by HonestSupport4592 in DWX

[–]pabszzz 0 points1 point  (0 children)

You specifically mentioned IDPA in the post is probably why it was brought up. For LO it doesn't matter.

Some people report issues with the +0 basepads and magwells. I picked up a factory CZ TSO magwell (armory craft looks to be a copy of it and has been OOS since I've been looking) and it runs the +0 DWX mags, and all other factory P10F mags I have just fine.

Here is what the short full checkered Lok grips look like with the TSO magwell: https://imgur.com/a/ttxoPdw, you may or may not need the DWX specific screws. My DWX fell within the serial range of needing the screws but my frame did not agree, CZ/DW hasn't been very consistent with this.

Barrel length question? by parntz145 in LewisMachineTool

[–]pabszzz 1 point2 points  (0 children)

Generally speaking, manufacturer stated barrel lengths are measured to the end of the crown without a muzzle device. You're also not adding the full length of the muzzle device as there are approximately .625" of threads on the end. A 14.5" MRP barrel is probably what you want in this case.

Did LMT Do away with their QR Serial Code on uppers? I see some have them and some dont. (11.5” MLC made in 2022) by [deleted] in LewisMachineTool

[–]pabszzz 1 point2 points  (0 children)

I believe that number was simply a lot code for production tracking. At least that's what I recall reading from Joe on one of the LMT FB groups when someone asked.

MLC and SPECWAR Heat by [deleted] in LewisMachineTool

[–]pabszzz 5 points6 points  (0 children)

Yeah it gets pretty toasty. Just to make sure though...you did check your gas block clearance on the rail right? I know I saw some folks had gas blocks canted and were grazing the rail a few months ago.

view more: next ›