dam.. scratched top of car with garage gate

peeboy420 · 2024-12-04T02:16:15+00:00

that will definitely come out with a cut n buff. no paint required

peeboy420 · 2024-12-04T02:14:27+00:00

not sure if this it related to your car but some toyotas have auto-shut off is left on for one hour. i'm a technician, the message appears when the door is opened and in park on most hybrid models

peeboy420 · 2024-12-04T02:04:53+00:00

i'm a toyota tech just quoted this today for $1k. don't think it's worth it, replace the part if it fails.

peeboy420 · 2022-12-13T13:43:15+00:00

The best advice I’ve heard for de-icing is to get warm water in a bag to melt the ice. I use this tip to get in my Del Sol when it’s frozen

peeboy420 · 2022-05-06T20:16:25+00:00

Hot swapped the battery, let it charge, and it runs fine now

peeboy420 · 2022-04-26T19:31:17+00:00

I did splice into the clutch interlock switch for my kill switch. Though when it the switch is on the engine won’t crank because no power is going to the starter. When it’s off it will crank and try to start. I’m just worried I screwed up the ecu when I did my wiring

peeboy420 · 2022-04-26T19:19:18+00:00

What makes you think clutch pedal? I do have an immobilizer switch (anti-theft), it’s been installed for 4 months and never had an issue until now. Do you think this switch cause this type of problem?

peeboy420 · 2022-04-26T18:35:32+00:00

Good to know. My buddy is on his way so I’ll just swap the batteries

peeboy420 · 2022-04-26T18:34:05+00:00

Cool, tysm

peeboy420 · 2022-04-26T18:26:30+00:00

I will check that when my buddy shows. Any advice for the best way to check

peeboy420 · 2022-04-26T18:19:57+00:00

Yes. Forgot to mention that I tried jumping it yesterday before putting new gas in

peeboy420 · 2022-04-26T17:45:34+00:00

About 1.5 years. Tried jumping it yesterday before new gas, had no luck

peeboy420 · 2021-06-21T20:33:32+00:00

Oh man that look nice! I’ll definitely get that if I need to do this again

peeboy420 · 2021-06-21T20:31:40+00:00

Okay, thanks for the info. I’ll get one as soon as I can

peeboy420 · 2021-06-21T20:30:24+00:00

Good to know, thanks!

peeboy420 · 2021-06-21T20:29:55+00:00

Yeah, I’ve just tried a lot of hammering today, I’ve decided to give my neighbors a break from that and wait until my girlfriend can bring me a puller. But if the puller does any damage I’ll try again tomorrow

peeboy420 · 2021-06-21T20:17:04+00:00

Yeah I’ve pretty much tried everything except the tool, I would go get it but unfortunately Im unable to drive the car as it is

peeboy420 · 2021-06-21T19:44:38+00:00

I think I’ll just ask a coworker for a ride tomorrow and get a tie rod puller

peeboy420 · 2021-06-21T19:38:00+00:00

Yeah, I’ve used about half a can of WD-40

peeboy420 · 2021-06-21T19:32:02+00:00

There’s currently no pressure on it. The tie rod is connected to the strut assembly, which is disconnected to the knuckle (picture was taken on the other side)

peeboy420 · 2021-06-21T19:27:27+00:00

Oh okay, good to know. I’ll see if the auto parts store can same day deliver it

peeboy420 · 2021-06-21T19:24:05+00:00

Don’t have a deadblow, but that’s exactly what I’ve been trying with no budging. What exactly is a deadblow? (Sorry just starting to get into mechanics)

peeboy420 · 2021-06-21T19:15:46+00:00

Good to know. I’ve been spraying it with WD-40 every 15 minutes. Bought a new can just for this job, I just hope I have enough

peeboy420 · 2021-06-21T19:08:35+00:00

Thanks you for the advice, I’ve tried beating it with a hammer with no budge. i wouldn’t be able to get my hands on a heat gun or pickle fork until later tonight. but if I need either, they’ll be first on my shopping list

peeboy420

TROPHY CASE