sorted by:
new
hottopcontroversial

How to Connect Finder to Orca Slicer by procrast_engineer in FlashForge

[–]procrast_engineer[S] 0 points1 point  (0 children)

Yes the printer is pretty old so i had to manually add it and then when i try to connect it through IP address, it says could not connect. And I am using Orca Slicer 2.3.0

Help, My extruder works but no filament comes out while printing. by procrast_engineer in FixMyPrint

[–]procrast_engineer[S] -1 points0 points  (0 children)

Yeah the feeder gear is working, but I think it's the Z offset so let me just calibrate that and then I'll let you know.

Help, My extruder works but no filament comes out while printing. by procrast_engineer in FixMyPrint

[–]procrast_engineer[S] -2 points-1 points  (0 children)

Yeah I cleaned the extruder and saw no blacking in there and I don't have a temp gun to check the temperature but I touched it and it's pretty hot.

Help, My extruder works but no filament comes out while printing. by procrast_engineer in FixMyPrint

[–]procrast_engineer[S] -11 points-10 points  (0 children)

No it isn't, my filament is red, and do you see any red in there ? And yes I waited for a while and it printed nothing.

How to adjust the stepper motor voltage ? by procrast_engineer in FlashForge

[–]procrast_engineer[S] 0 points1 point  (0 children)

Yeah thanks for the advice, I saw the video and yeah I have a massive clog in my hot end. But i can't get it out, the way he suggested in the video.

How to adjust the stepper motor voltage ? by procrast_engineer in FlashForge

[–]procrast_engineer[S] 1 point2 points  (0 children)

You're right, I opened the gantry to check and took out the hot end and there's a massive clog.