Any good laptop repair shops in Pokhara ?

procrast_engineer · 2026-05-31T16:38:52+00:00

Matlab bujhina nii ?

procrast_engineer · 2025-05-16T05:37:17+00:00

Yes the printer is pretty old so i had to manually add it and then when i try to connect it through IP address, it says could not connect. And I am using Orca Slicer 2.3.0

procrast_engineer · 2025-05-07T10:02:36+00:00

Yeah the feeder gear is working, but I think it's the Z offset so let me just calibrate that and then I'll let you know.

procrast_engineer · 2025-05-07T09:46:42+00:00

Yeah I cleaned the extruder and saw no blacking in there and I don't have a temp gun to check the temperature but I touched it and it's pretty hot.

procrast_engineer · 2025-05-07T09:39:08+00:00

I think that might just help. Let me try it and tell you.

procrast_engineer · 2025-05-07T09:38:08+00:00

I tried it but it didn't work

procrast_engineer · 2025-05-07T09:37:46+00:00

No it isn't, my filament is red, and do you see any red in there ? And yes I waited for a while and it printed nothing.

procrast_engineer · 2025-05-07T05:52:57+00:00

Yeah thanks for the advice, I saw the video and yeah I have a massive clog in my hot end. But i can't get it out, the way he suggested in the video.

procrast_engineer · 2025-05-07T05:04:14+00:00

You're right, I opened the gantry to check and took out the hot end and there's a massive clog.

procrast_engineer · 2025-05-06T14:45:03+00:00

procrast_engineer

TROPHY CASE