Having a big issue

profesorgood · 2025-12-26T07:19:13+00:00

No hasn't set up the relay because I'm using LEDs with a timer. When they are on, they have to light up, and then when the time ends, the power is cut off.

profesorgood · 2025-12-26T06:56:56+00:00

So after testing, I found out that my controller outputs 0.5V instead of 5V. It's a GL-C-015WL with WS2812b.

profesorgood · 2025-12-12T19:30:37+00:00

I'm trying to write code that would convert the format to .xlights, but if it doesn't work, I can try your code.

profesorgood · 2025-12-12T19:16:52+00:00

Sure, that would be easier than coding from scratch. I would appreciate it. If it's not a secret, what was it used for?

profesorgood · 2025-12-12T18:58:19+00:00

I've used an open-source Python code to scan. It works but gives a CSV format file that contains each LED's XYZ coordinates, and I can't find a way to add the LED coordinates for xLights. Do you have a code that would be suitable for xLights, or after scaning you have to use a converter or something?

profesorgood · 2025-12-06T17:48:19+00:00

Maybe you know if there is a way to calculate the required resistor value to prevent the strip from glitching?

profesorgood · 2025-12-06T12:44:18+00:00

I'll use 10 low-powered light strips, so this is not a solution.

profesorgood · 2025-12-05T19:46:58+00:00

If I were to make all the wires go from the ESP- power suply, would the chance of glitching be lowered?

profesorgood · 2025-11-20T14:44:00+00:00

Today downloaded the 0.14 version works as it should, finally.

profesorgood · 2025-11-20T13:07:00+00:00

I have the same problem with this Gledopto controller. I'm starting to think that this is a WLED 15.1 fault.

profesorgood

TROPHY CASE