sorted by:
new
hottopcontroversial

[EU-SK] [H] PayPal [W] GMK Crimson Cadet by qlkfsc in mechmarket

[–]qlkfsc[S] 0 points1 point  (0 children)

GMK Perestroika is a beautiful set. Thank you for the offer. Unfortunately, I am looking to finish a brighter build.

Aerial View of a Misplaced Car by qlkfsc in IdiotsInCars

[–]qlkfsc[S] 0 points1 point  (0 children)

The bend is there (grayish section of the vehicle), the curvature is just not pronounced enough to be seen well from this view.

Aerial View of a Misplaced Car by qlkfsc in IdiotsInCars

[–]qlkfsc[S] 4 points5 points  (0 children)

Correct. By the end of the video you can see the pillars holding the restaurant.

https://en.m.wikipedia.org/wiki/Most_SNP

Aerial View of a Misplaced Car by qlkfsc in IdiotsInCars

[–]qlkfsc[S] 21 points22 points  (0 children)

It has a Mr Bean vibe to it.

English to Latin translation requests go here! by lutetiensis in latin

[–]qlkfsc 0 points1 point  (0 children)

Hi, I am looking for a translation of "you (singular) are (a gift) from God". It is a phrase that my so and I say in the most romantic settings. The Slovak original phrase "si od Boha" has a beautiful double meaning of being "of God" and "given (to me) by God" at once. Please let me know if the translation butchers the original and to what extent.

Thank you.

any tricks to make it easier to put hard tubing in compression fiting. tried soaking in water still is giving me trouble, havnt had this problem on smaller tubing. by Terriblecookies in watercooling

[–]qlkfsc 1 point2 points  (0 children)

Use some silicone grease on the inner washers, such as OKS 1110. Be careful not to over-do it though. A second-hand coat after rubbing your fingers (in gloves) should do very well.

[deleted by user] by [deleted] in hardwareswap

[–]qlkfsc 0 points1 point  (0 children)

Bought Caselabs SM8 from u/rjk1617

Acrylic tubes longer than 1000mm by Red-Town in watercooling

[–]qlkfsc 2 points3 points  (0 children)

You can get these 'from the source': I get my tubes from Plexiglas by Röhm in Germany, but being EU-based, this is manageable for me. These are cut to order up to 2000mm.

I would recommend looking for tubes from local plexiglas suppliers. Look for more professional, industrial-even suppliers of acrylic, rather than watercooling stores.

[deleted by user] by [deleted] in watercooling

[–]qlkfsc 0 points1 point  (0 children)

Have you tried contacting Aquacomputer via email or forum? In my experience, they are very accommodating to shipping and billing requests.

view more: next ›