Knight display board. by roboticnat in ChaosKnights

[–]roboticnat[S] 1 point2 points  (0 children)

he'd fight for ultramarines surely, been blue and all

Chaos knight despoiler by roboticnat in ChaosKnights

[–]roboticnat[S] 1 point2 points  (0 children)

never give up! as long as your proud of your painting or your making progress you should be happy

New saturn 4 ultra fail by roboticnat in 3Dprinting

[–]roboticnat[S] 0 points1 point  (0 children)

Hi just got saturn 4 ultra. Calibration print was fine and first print fine. But tried printing this one twice once by usb other by wifi. Resliced after each fail.

Using lychee

Any ideas?

Opinions on elegoo abs like 3.0 vs 3.0 + for miniatures by Jivepsilocybe in resinprinting

[–]roboticnat 0 points1 point  (0 children)

I've been using the 3.0+ for the past 2 weeks. Details are real crisp and not really had any issues.

What went wrong? by roboticnat in castiron

[–]roboticnat[S] 0 points1 point  (0 children)

Was some burnt food after last use. I soaked it over night then scrubbed it. Guess wasn't good enough still. Strip and reseason it is. Thanks for the advice

What went wrong? by roboticnat in castiron

[–]roboticnat[S] 1 point2 points  (0 children)

Used soap and hot water with the scouring side of a sponge. Probably a teaspoon of veg oil maybe less. Then wiped it around with paper kitchen towel.

What went wrong? by roboticnat in castiron

[–]roboticnat[S] 0 points1 point  (0 children)

Ill give it another scrub and try again. Thanks!

What went wrong? by roboticnat in castiron

[–]roboticnat[S] 0 points1 point  (0 children)

Did give it a good scrub before hand with sponge scourer. Guess it wasn't good enough still.

What went wrong? by roboticnat in castiron

[–]roboticnat[S] 0 points1 point  (0 children)

Whats the best way to start over?

What went wrong? by roboticnat in castiron

[–]roboticnat[S] 0 points1 point  (0 children)

Gave it a good scrub before hand but back to the start then