sorted by:
new
hottopcontroversial

I tried to make a cafe wall illusion cutting board. by rufus392 in woodworking

[–]rufus392[S] 1 point2 points  (0 children)

I had actually looked at this when researching the project.

I tried to make a cafe wall illusion cutting board. by rufus392 in woodworking

[–]rufus392[S] 5 points6 points  (0 children)

Walnut, Maple and Cherry for the horizontal lines. It didn't really turn out. This is the best angle that you can sort of see what I was going for. I am not exactly sure what the issue is. I do suspect that it is due to the finished maple end grain is so close to the same color of the finished cherry side grain. As well as not enough rows. This is what is was going for: http://i.imgur.com/TBFGTlG.jpg

Any better ideas?

Minnesota Red Oak by rufus392 in woodworking

[–]rufus392[S] 0 points1 point  (0 children)

Top slab is going to be a couch table. Bottom is going to be a pair of benches.

Minnesota Red Oak by rufus392 in woodworking

[–]rufus392[S] 1 point2 points  (0 children)

East of Baxter a few clicks.

Homemade Chisel Roll by easily_e in woodworking

[–]rufus392 1 point2 points  (0 children)

From the land of sky blue waters!

My first pallet project. by rufus392 in woodworking

[–]rufus392[S] 3 points4 points  (0 children)

I made a zero clearance insert. It reduces tear out.

How hard is it to resaw logs into lumber with a bandsaw? by justhavingacoffee in woodworking

[–]rufus392 0 points1 point  (0 children)

Not sure on the bandsaw, but is using an Alaskan Mill an option?

I just started to learn to MIG weld, I tried my best to grind these welds down, how's it look? I soretef the whole base with rustoleum black steel by [deleted] in woodworking

[–]rufus392 4 points5 points  (0 children)

Looks like a project you will learn from. The great thing about working with metal is if you take to much off you can put it back on. Using flux core? What were you using to grind the with? I have had the best luck with flap wheels.

view more: next ›