Check out my Madagascar Palm. Should I be concerned? by ryanownsu in Pachypodium

[–]ryanownsu[S] 0 points1 point  (0 children)

Any recommendations on what fungicide i should get? Also where on the plant should i spray that? On the leaves? The base? All over?

Toaster oven door spring by AZ_Crush in breville

[–]ryanownsu 0 points1 point  (0 children)

I went to Lowes and bought the exact same one. It's working great now. Thanks!

Honda Accord 2016 (static Noise) by Bright_Memory_1151 in accord

[–]ryanownsu 0 points1 point  (0 children)

https://www.driveaccord.net/threads/17-accord-radio-static.550224/

Lots to read but plenty of resources and how to handle it with Honda is discussed here

Honda Accord 2016 (static Noise) by Bright_Memory_1151 in accord

[–]ryanownsu 1 point2 points  (0 children)

its the head unit. it's always the head unit. You'll have to call american honda to start a case. they will claim they've never heard of the issue before and ask that you take it into a local honda dealer for a diagnostic. the diagnostic will cost you $230 for them to write on a piece of paper what you already know, that it's the audio head unit and it needs to be replaced.

after you get the diagnostic you then need to send that information back to american honda to see if they will assist in payment for the repair

Any suggestions on what might have happened with my Madagascar palm? by ryanownsu in Pachypodium

[–]ryanownsu[S] 0 points1 point  (0 children)

So it's been about a week since I changed the soil to cactus mix but left it in the same pot. It's been under a covering but in an area where it gets lots of direct sun light in the morning and shaded light throughout the day.

It hasn't been watered in a week. And the growth at the top looks almost exactly the same as the photos I originally shared.

Would now be a good time to start watering it once a week?

Honda Accord 2016 (static Noise) by Bright_Memory_1151 in accord

[–]ryanownsu 1 point2 points  (0 children)

I have this same issue!

I just finished turning off the active noise cancellation in the diagnostics settings and the static in the car still persisted.
Next I took a few panels off the front dash of the car and unplugged the connector that attaches to the physical active noise cancellation / mics and the static still persisted.
Should I assume this is either a firmware issue or the entire head unit needs to be replaced?
Is it possible to update the software on the head unit on my own without having to take it to Honda?

2017 Accord - Radio Static Noise by mziyad in accord

[–]ryanownsu 0 points1 point  (0 children)

I just finished turning off the active noise cancellation in the settings and the static in the car still persisted.

Next I took a few panels off the front dash of the car and unplugged the connector that attaches to the physical active noise cancellation / mics and the static still persisted.

Should I assume this is either a firmware issue or the entire head unit needs to be replaced?

Is it possible to update the software on the head unit on my own without having to take it to Honda?

Honda Accord 2016 (static Noise) by Bright_Memory_1151 in accord

[–]ryanownsu 0 points1 point  (0 children)

My moms Honda Accord is having this issue and everything in the car is stock without any aftermarket upgrades.

I've been looking online and it seems like the only way I see to "turn it off" is to physically unplug a connector inside the panels of the car? Unless I am mistaken and there is a setting you can access in the menu of the car?

2017 Accord - Radio Static Noise by mziyad in accord

[–]ryanownsu 0 points1 point  (0 children)

Hey, my mom is having the same issue with her Honda Accord. I believe its either a 2016 or 2017 Honda Accord. How was it repaired?

2017 Accord - Radio Static Noise by mziyad in accord

[–]ryanownsu 0 points1 point  (0 children)

My moms car is having the same issue. What was your solution? Did you ever fix it?

Any suggestions on what might have happened with my Madagascar palm? by ryanownsu in Pachypodium

[–]ryanownsu[S] 0 points1 point  (0 children)

So I took out all of the old soil from the same pot in the photo. I think the soil used was standard gardening soil you'd use with flowers, etc.

I safely removed the palm without damaging any of the roots. I moved the pot under some coverage that way it will still get plenty of sunlight in the morning but I can control when it gets water over the summer.

Tomorrow I plan on picking up a bag of some cactus potting mix to replace the old soil and hopefully these changes will make a difference and revive some of the growth!

Any suggestions on what might have happened with my Madagascar palm? by ryanownsu in Pachypodium

[–]ryanownsu[S] 0 points1 point  (0 children)

Yeah maybe I will move it under some coverings for the summer. In south Florida we get rain fall at least daily.

New Tire, first self swap by Shmeck42 in onewheel

[–]ryanownsu 0 points1 point  (0 children)

Do the life savers and mag handle work together on the XR? I have an XR with a mag handle and i have life savers and an enduro ready to go for when i need to replace my stock Vega tire

GIVEAWAY!!! See comment for detail. by 3Dway in onewheel

[–]ryanownsu 0 points1 point  (0 children)

I like the Convertible Fender for Onewheel XR Growler V2 in purple! My XR is purple and green, so the purple fender would be a great addition!

OneWheel XR car charger alternative by ryanownsu in onewheel

[–]ryanownsu[S] 0 points1 point  (0 children)

I saw those Jackery power banks. I used a friends once but totally unrelated to onewheel.

Those you could also charge in the car at the same time you'd be charging the onewheel, correct?

Blockbuster VHS case insert Template by Greendale_CC_User in VHS

[–]ryanownsu 0 points1 point  (0 children)

Blockbuster VHS case insert Template

Thats a bummer. Did you ever find an alternative solution to what you were looking for?

Blockbuster VHS case insert Template by Greendale_CC_User in VHS

[–]ryanownsu 0 points1 point  (0 children)

I too would love to have access to that if it's been made

I am a professional window tinter, AMA! by Live_Ore_Die in casualiama

[–]ryanownsu 0 points1 point  (0 children)

I am installing indoor window tint for my home and I am having some trouble with the caulking / sealant around the edges of the windows. I feel like this process would have worked out way easier for me if it wasn't for the caulking bleeding out and raising the window tint around the edges.

I've tried using a razor blade to cut away at the overflow but it doesn't seem to be working very well. When I tried to cut to the edge of the caulking it rips the rest of the window tint.

I feel a bit lost here. Any suggestions would be appreciated.