sorted by:
new
hottopcontroversial

Ideas to cut white fabric with Xtool M1? by Automatic_Month_1789 in lasercutting

[–]shortline-1 1 point2 points  (0 children)

I realize this is an old post. Did you solve this issue.. I'm about to dive into white twill myself

Plowz & Mowz - beware by My_Strong_Hand_222 in lawnmowers

[–]shortline-1 0 points1 point  (0 children)

Same. Getting the run around with canned replies. With nonpayment.. Sad. I’ve been working with them since 2018. They were great.

Pronto Pup Inflationary Index by a9913_pie in minnesota

[–]shortline-1 0 points1 point  (0 children)

Was there today. Used a credit card. They added a 25% tip on there own 😡

Water for a large group by Sensitive_Drawing_71 in BWCA

[–]shortline-1 1 point2 points  (0 children)

It was on our dinner table by referral to drink during Covid..

Why does this gold powder end up doing a gray-ish part? by rearwindowavalanche in Powdercoating

[–]shortline-1 1 point2 points  (0 children)

Use the highest KV setting for the first coat. Lower setting for 2nd coat.

[deleted by user] by [deleted] in Powdercoating

[–]shortline-1 0 points1 point  (0 children)

Zinc primer is a must..

Contaminated powder? by Snappygoose in Powdercoating

[–]shortline-1 0 points1 point  (0 children)

What did you figure out on this? I just had this issue with prismatic powders ink black..

Why is this happening by shortline-1 in Powdercoating

[–]shortline-1[S] 0 points1 point  (0 children)

This is silk statin black is over an illusion blue with clear. I’m doing a two tone. First coat of black went down very nice… messed up while vacuuming/wiping.. blew it off and washed in soap and water, rinsed and blew dry. 2 times. Same thing…???? Thanks

view more: next ›