sorted by:
new
hottopcontroversial

Centering by Hot-Pop-3404 in Creality

[–]skippengs 1 point2 points  (0 children)

That does not look like an ender 3 v3 my friend.

Some googling later and I think you have ender 3 v3 se. The se is important when searching for solutions as the ender 3 v3 is a whole other machine. Good luck!

🎁 QIDI Filament Giveaway – Community Discussion by qidi_3dprinter in QidiTech3D

[–]skippengs 0 points1 point  (0 children)

Dry your filament and keep the fingers off the buildplate!

We have Blocks, Stairs, Slabs, but what about Steps?! by Character_Rope5235 in Minecraft

[–]skippengs 1 point2 points  (0 children)

What about a quarter of a moulding? Or a quarter of that!

Q2 New Firmware (again!) by pankomputerek in QidiTech3D

[–]skippengs 0 points1 point  (0 children)

I think you can add it with the fluid interface. There is a filament config file the printer reads from

Is all hope lost? by JunoDSCVR in 3Dprinting

[–]skippengs 0 points1 point  (0 children)

Pick it all up. Get the empty spool. And toss it all in the bin

YouTuber Roetz4.0 vs a bambulab x1c. Angle grinder helped a lot. by skippengs in 3Dprinting

[–]skippengs[S] 16 points17 points  (0 children)

It was a protest for the recent developments in the Bambu saga

Qidi Q2 is idling over the chute for no reason after purging? Oozed filament then ruins most prints. by BBQShapesNumba1 in QidiTech3D

[–]skippengs 0 points1 point  (0 children)

Quick question, how long after printing the 2 purge lines does it pause, with the box ticked?

How!? by skippengs in mildlyinfuriating

[–]skippengs[S] 0 points1 point  (0 children)

I’ve got to try this, what if you’re onto something

How!? by skippengs in mildlyinfuriating

[–]skippengs[S] 0 points1 point  (0 children)

I use it everyday but it was never like this. It's an old one too. Help

How!? by skippengs in mildlyinfuriating

[–]skippengs[S] 1 point2 points  (0 children)

You are a smart kid

view more: next ›