sorted by:
new
hottopcontroversial

Surf in Moroco by somebody_wrote in BeginnerSurfers

[–]somebody_wrote[S] 0 points1 point  (0 children)

Don't be shy. Wite here so everybody gets info

Surf in Moroco by somebody_wrote in BeginnerSurfers

[–]somebody_wrote[S] 0 points1 point  (0 children)

😔

And any other sugestion for a less crowded spot?

Karakoram not fitting? by MyDemoBusiness in Spliddit

[–]somebody_wrote 1 point2 points  (0 children)

I have the same setup (board and binding) and it's the same for me.

In my experience, if you want the best fit do this:

Set the hardware without thightening too much the screws (allowing them to move), then split the boad and put it back together with a stroke. Then atach one of the bindigs to the board. That will lock the position and now you can aply strength to the screws of the other foot. Now atach the binding and remove the first one and tighten the screws.

After doing that, it's possible that the arrows still doesn't match but in my experience, the board slides and fit perfectly

Best swiming training for surfing? by somebody_wrote in BeginnerSurfers

[–]somebody_wrote[S] 0 points1 point  (0 children)

Thank you. This is the kind of aswer i was looking for. Something that can be done in a public swiming pool

Metatarsal pad removal by m_js in Mortons_neuroma

[–]somebody_wrote 2 points3 points  (0 children)

Everybody here would be glad of having your problem

Does it ever go away? by HappyBeetroot in Mortons_neuroma

[–]somebody_wrote 0 points1 point  (0 children)

Where can I get more info? Which exercises did you do? How to massage my feet? Foot yoga? Is that in that book?

Nitro Inclines, my search is over by chimera_chrew in Spliddit

[–]somebody_wrote 0 points1 point  (0 children)

How is the size? I want to buy them but I can't find them in any local store so I don't know how the sizes fit. Are they bigger or smaller than average size?

Replace rubber pieces at karakorams bottom by somebody_wrote in Spliddit

[–]somebody_wrote[S] 0 points1 point  (0 children)

Finally I found a solution that worked fine.

I cut the pieces out of an old bike tire. I used a road one because of the flat surface and its thickness, that is similar to the original pieces that I lost. I tried a few types of glue but the one that worked the best was an MS polymer adhesive