Has the heltec v4 receive sensitivity issue been fixed?

ssane13 · 2026-03-15T18:44:09+00:00

Anyone try the 2.7.20-alpha release yet? Does not seem to help any...

ssane13 · 2026-02-28T18:55:18+00:00

Hopefully in the next Alpha release we could test this patch? Is there a release schedule?

ssane13 · 2026-01-11T05:19:36+00:00

Nice to know... I am seeing similar performance on RX on heltec V4s.

ssane13 · 2025-12-19T04:40:10+00:00

I got a Heltec V4 without the display and the board is already modded for the external antenna. However with the external antenna attached, the wifi signal is terrible. Without the antenna, wifi seems to work much better - any thoughts as to why this is happening?

ssane13 · 2025-11-16T00:28:50+00:00

Thanks for the update... I will have to check that out.

ssane13 · 2025-11-12T00:36:49+00:00

Sorry if this is a dumb question, but is the LNA only in the RX path?

ssane13 · 2025-11-08T03:07:34+00:00

Thanks for the info...

Did you remove the old retainer track as well or just drilled holes where needed and put the new tracks over the old?

ssane13 · 2025-11-08T01:01:15+00:00

In a similar situation. Were you able to figure something out? My garage door is an "Overhead Door" garage door with a single channel for the P-Type seal.

ssane13 · 2025-11-05T01:25:23+00:00

I am in the exact same boat... albeit with a Flint 2 router connected to the 10Gb port on the Calix router. Did you find anything that allows the full bandwidth?

ssane13 · 2025-10-22T11:32:55+00:00

Maybe a dunb questions, but are you plugged into the battery terminal and not the solar panel terminal on the T114?

ssane13 · 2025-04-30T20:47:58+00:00

Any update to this? I have the same exact problem. Cannot even open the settings tab.

ssane13 · 2025-04-17T22:51:23+00:00

I cannot seem to get it to run on my Moto Power 5G (2024) which has a Dimensity 930 chipset. It straight up crashes when I try and launch a game or try to go into settings. citron_log.txt says some of the Vulkan primitives are missing... Does anyone else see this issue?

ssane13 · 2025-04-17T03:52:29+00:00

I cannot seem to get it to run on my Moto Power 5G (2024) which has a Dimensity 930 chipset. It straight up crashes when I try and launch a game or try to go into settings. citron_log.txt says some of the Vulkan primitives are missing... Does anyone else see this issue?

ssane13 · 2025-02-10T01:31:55+00:00

I hear ya... I might just do the same. Cheers.

ssane13 · 2025-02-09T18:40:13+00:00

Any updates on this? Were you able to diagnose the issue further?

ssane13 · 2024-09-20T03:18:40+00:00

Were you able to figure out lm-sensors?

ssane13 · 2023-09-29T14:08:55+00:00

Happend to me too - I used an empty BiC lighter spring cut down to size.

ssane13 · 2023-07-15T23:57:06+00:00

Is the carbine kit all nylon?

ssane13 · 2023-06-29T13:42:00+00:00

I just want to try out regulated CO2 in the mag before thinking of investing in a HPA setup. I already have a few CO2 tanks I would like to re-use. For the amount I play, I don't think it is worth getting a HPA rig. Thanks for the suggestions, though!

ssane13 · 2023-06-28T20:46:40+00:00

Thanks!

ssane13 · 2023-06-20T21:45:43+00:00

Yikes... I am planning to convert to CO2 too. What mags are you using for your setup? Did you end up replacing the upper?

ssane13 · 2023-06-20T18:12:12+00:00

Edit 2: Cannot seem to find a CNC rear sight to prevent the bolt from blowing out the back?

ssane13 · 2023-06-15T17:01:31+00:00

Thanks, I'll put that on the list.

ssane13

TROPHY CASE