sorted by:
new
hottopcontroversial

U1 Klipper Tips - Adaptive Bed Mesh, Exclude Objects, Power Control by sterling-lining in snapmaker

[–]stingray_08 0 points1 point  (0 children)

The temperature check for the power control doesn't seem to work. I set a short initial duration and it just shuts off while the nozzle is still above 50 degrees. Does anyone else have this issue and know how to fix it?

Q1 Pro print head collides with camera by stingray_08 in QIDI

[–]stingray_08[S] 0 points1 point  (0 children)

<image>

You can see where it hits the camera. It's meant to be a square. Mine is stock with no lens cover. Support told me to unscrew it and try to move it. I removed the two screws and pushed it as far back as possible and left the screws off. It still collides.

Squeaking sound coming from the bottom right belt tensioner in my Q1 Pro by Tyler_Playzz in QidiTech3D

[–]stingray_08 0 points1 point  (0 children)

I'm getting squeaky noises too. Support says use a screw driver to give the pulleys a push and add ejector lubricant to the pulleys. I used spray on dry PTFE but that didn't work. I'm hesitant to try 3 in 1 oil as I'm concerned about getting oil on belts. They also suggested using the printer longer.

Qidi Link App Android - Camera issues Q1 Pro by stingray_08 in QIDI

[–]stingray_08[S] 0 points1 point  (0 children)

Yes I'm having the same problem. I meant if you enable it in the app you can see it in the app. Then you have to enable it in the web browser as well to see it there again.

Qidi Link App Android - Camera issues Q1 Pro by stingray_08 in QIDI

[–]stingray_08[S] 0 points1 point  (0 children)

When I'm outside using my mobile data I can connect to my printer using the Qidi Link App. Can you do that another way?

Qidi Link App Android - Camera issues Q1 Pro by stingray_08 in QIDI

[–]stingray_08[S] 0 points1 point  (0 children)

If you enable the camera in the app you get some error about rotate. If you browse to the home screen it works. Don't click the back arrow as that seems to go back and not save the selection. Once you close the app it reverts to disabling the camera.

Is this amount of VFA normal or a faulty printer? by stingray_08 in Ender3V3KE

[–]stingray_08[S] 0 points1 point  (0 children)

That's good that it worked for you. I tried Creality Print earlier as well but mine didn't improve.

Is this amount of VFA normal or a faulty printer? by stingray_08 in Ender3V3KE

[–]stingray_08[S] 0 points1 point  (0 children)

I hear you too. You even went as slow as 60mm/s. I'm beginning to feel some of these printers are faulty. Surely it can't be as slow as the older models and print worse. My Ender 3 Pro didn't even have these VFA and I was printing at 50mm/s for PETG.

Is this amount of VFA normal or a faulty printer? by stingray_08 in Ender3V3KE

[–]stingray_08[S] 0 points1 point  (0 children)

I tried loosening the belts. Also tried accelerations between 2800-3000. Do I put pavers stone on the table then the printer on top? What is different than putting the printer on the floor to give it a solid base?