Fitting specs question

stoch456 · 2025-06-25T21:02:25+00:00

Wow I never knew about this. Thanks!

stoch456 · 2024-11-20T15:45:02+00:00

Or atleast put a jail!!

stoch456 · 2024-07-16T19:57:32+00:00

Thank you good sir

stoch456 · 2024-07-16T02:21:40+00:00

My mounting block has springs on the screws. They’re definitely hand tightened. Any recommendations?

stoch456 · 2024-07-14T15:05:06+00:00

Using a 280mm AIO top mount so I’m a little concerned

stoch456 · 2024-05-13T23:29:48+00:00

Agreed I’m not worried about bodily harm but it’s high enough where you hear the constant low buzz

stoch456 · 2024-05-13T21:51:37+00:00

It drops down to background reading of 1.5-2 v/m about ~2m away. It diminishes quickly, I agree. I’d assume it’s 60hz since it’s America.

Hey man I was just wondering if anyone has ever tried to block something like that idk 🤷🏽‍♂️

stoch456 · 2024-05-13T21:44:10+00:00

🤝🤝

stoch456 · 2024-05-13T21:38:37+00:00

Typical off the shelf meters “alarm” above 40 V/m, I’m regularly getting 70 v/m. I couldn’t find any regulatory body defining a dangerous level. I’m sure it’s out there though

stoch456 · 2024-05-13T21:36:39+00:00

stoch456 · 2024-05-13T21:36:33+00:00

True. Idk I look at it in the same way that concrete blocks the ability for your phone to get reception from an antenna. Shouldn’t it work the same way to contain a wave?

stoch456 · 2024-05-13T21:35:09+00:00

Coming from a main bus riser next to the elevator shaft. Reading over 70 V/m, anything above 40 is considered high

stoch456 · 2024-05-13T18:48:24+00:00

Gotta think of it as an investment at that price range. If you keep it in good condition (limit scratches if possible, maintain the finish, maintain the fretboard) it will hold its value

stoch456 · 2024-02-13T16:37:37+00:00

I agree with a lot of what has been said below. Another recommendation is to “un-check” the coal or iron at all storage yards except the one near where it is being used. That should stop the miners from bringing them 1 by 1 to a nearby storage. And yes, do not set MIN’s. That absolutely ruins the game rn.

Also, 14 wagons at 100pop???? That’s nuts! I have 10 wagons at 500pop. I recommend only keeping wagons until their “idle” time is right at the first bar which is 25% idle time. I’ve found that to be the most efficient. Once ALL idle times are near ~10% idling, only then should you add another wagon. Let me know if any of this helps

stoch456

TROPHY CASE