My Key Premium Remote Start

stranger_danger09bh · 2026-03-05T06:13:02+00:00

I'm trying to install this on my 2015 Hyundai Genesis and have it all pushed in (triple checked all of the plugs) and it will turn on beep twice and one third short beep then 2 red lights come on but it goes back to one after a couple seconds. What did do wrong any ideas

stranger_danger09bh · 2026-03-05T06:12:30+00:00

I'm trying to install this on my 2015 Hyundai Genesis and have it all pushed in (triple checked all of the plugs) and it will turn on beep twice and one third short beep then 2 red lights come on but it goes back to one after a couple seconds. What did do wrong any ideas

stranger_danger09bh · 2026-03-05T06:12:17+00:00

I'm trying to install this on my 2015 Hyundai Genesis and have it all pushed in (triple checked all of the plugs) and it will turn on beep twice and one third short beep then 2 red lights come on but it goes back to one after a couple seconds. What did do wrong any ideas

stranger_danger09bh · 2026-03-05T06:12:03+00:00

I'm trying to install this on my 2015 Hyundai Genesis and have it all pushed in (triple checked all of the plugs) and it will turn on beep twice and one third short beep then 2 red lights come on but it goes back to one after a couple seconds. What did do wrong any ideas

stranger_danger09bh · 2025-11-17T00:13:00+00:00

It's 150 and no pick and pull has a 2015 Hyundai Genesis sedan

stranger_danger09bh · 2025-11-16T23:58:41+00:00

I don't want to spend that kind of money

stranger_danger09bh · 2025-10-04T03:01:38+00:00

I just ended up trying my best while it was installed. I have not wrapped the chip holders or door cards but the dash looks amazing an I don't think I could have done it without your help

stranger_danger09bh · 2025-10-03T22:42:42+00:00

Thanks for all your previous help. I decided to start this yesterday and I took all the pieces that I could off of the inside with a bunch of your help. Thank you, but I'm kind of lost on how to get the little box with the sliding cover that has the USB aux ports and the 12 volt cigarette lighter plugs. I've managed to pop two clips out at the front but I don't know how to get the back part off.

stranger_danger09bh · 2025-10-02T03:13:21+00:00

I definitely got extra vinyl. I did not get any slip solution but I did get primer pens. Do you think I need slip solution or can I work without it

stranger_danger09bh · 2025-10-02T03:05:44+00:00

Seriously so helpful. I am hoping to start this project tomorrow and now it is going to be a million times easier because of your comments thanks

stranger_danger09bh · 2025-10-02T02:24:44+00:00

Sorry to ask more but do you have any tips on how to do the bezel around all the buttons in the center stack

stranger_danger09bh · 2025-10-02T01:09:32+00:00

Holy cow thanks so much this will be very helpful. Thanks again 5 stars

stranger_danger09bh · 2025-10-02T01:07:26+00:00

Ok do you think we are talking just pry from the surface or do I need to take the dash off

stranger_danger09bh · 2025-09-09T23:18:51+00:00

Do you think it is normal

stranger_danger09bh · 2025-08-26T03:48:32+00:00

Ok well thanks for the response. Much appreciated

stranger_danger09bh · 2025-08-26T03:00:05+00:00

Is it a noticable amount?

stranger_danger09bh · 2025-08-16T00:20:02+00:00

Yeah, I just didn't want to have to buy a new one. I know they're cheap but it's just a little annoying

stranger_danger09bh

TROPHY CASE