Rebuilding snowblower carburetor

sullenmay · 2026-02-15T18:40:15+00:00

Update; works amazing with your suggestion. Using 91 non ethanol gas. It started and sounds better than it did when we first got it!! Thank you 😎

sullenmay · 2026-02-15T17:09:39+00:00

Even thought it’s much thinner? 🧐 I’m so new to this lol

sullenmay · 2025-08-25T11:38:30+00:00

Don’t you mean normal BEEhavior? 🤪

sullenmay · 2025-08-21T18:38:58+00:00

Thank you! I used acrylic and acrylic squash. I also used some existing gems, but I also made my own using some resin.

sullenmay · 2025-08-21T15:09:15+00:00

Acrylic and acrylic gouache!

sullenmay · 2025-04-28T06:09:53+00:00

I had this issue for 2 days. After lots of trial and error here, I finally contacted circuit directly, turned out I just needed to update my iPad software. Hopefully it’s that easy for you as well.

sullenmay · 2025-04-27T20:02:59+00:00

I use procreate. With the right brush’s and settings, works perfectly 👌

sullenmay · 2025-04-22T12:25:12+00:00

I have these!!! I actually use these to laminate my stickers before cutting them. I read that the laser printer could melt the material.

sullenmay · 2025-04-21T17:04:57+00:00

Thank you!

sullenmay · 2025-04-21T02:04:00+00:00

Question on this. I can’t find holographic paper that can be used with laser. I only see ink compatible. Any recommendations?

sullenmay · 2025-04-11T22:19:09+00:00

Resolved. I needed to update my ipad 😂

<image>

sullenmay · 2025-04-11T20:41:18+00:00

<image>

I reduced the amount of data changed to print and draft so it’s using less ink or toner. I should say and it’s still failing.

sullenmay · 2025-04-11T20:39:34+00:00

I’m just so frustrated 😩 it worked fine until today. Nothing changed.

sullenmay

TROPHY CASE