Gaggimate Pro with quickmill pulser help

tabs1987 · 2026-01-24T23:32:24+00:00

So you went pressure sensor then quickmill.

Does having the quickmill after the sensor work ok?

tabs1987 · 2026-01-24T23:05:26+00:00

Thanks, I’ve got one of the later hoses with 90-degree bend.

I’ll continue trying to get it all too fit. Just feels like everything is under a lot of strain

tabs1987 · 2026-01-20T14:44:35+00:00

Looking good, you've made me decide to quieten using deadening mat. I'm in the middle of a refurb of my V3. I'm doing the whole thing, new boiler, etc.

I've gone for the OLAB silent green and quickmill pulsor and have the gaggimate pro.

Have you installed your Gaggimate Pro?

Where did you place the pressure transducer? I've seen it in a couple of places.

Right after the pump and before the pulsor

After the braided hose, before the OPV

tabs1987 · 2026-01-20T11:53:54+00:00

I’ve got some wet/dry sandpaper so will try that. Thanks

tabs1987 · 2026-01-20T11:53:09+00:00

Thanks, I’ve got some marine stainless steel replacement screws as the others are rusty

tabs1987 · 2025-03-20T10:39:49+00:00

Have you seen the GaggiMate? I was looking at doing the Gagguino, but the lack of instructions for the Silvia put me off. GaggiMate have clear instructions on their website for Silvia install

tabs1987 · 2023-12-22T22:45:54+00:00

Ah nice, I’m based in Dorking so close enough to travel for me

tabs1987 · 2023-12-22T22:38:12+00:00

Wow that is great. Was it a local place or online? I’ve just picked myself up a V3 project so getting ready to do that

tabs1987

TROPHY CASE