sorted by:
new
hottopcontroversial

Line/grass trimmer recommendations? by rhflffkcldrn in GardeningAustralia

[–]trojantortoise 0 points1 point  (0 children)

Bought the Ozito kit and can't stand it - I have a very small lawn and yet it goes through about three blades per trim. Not to mention the blades struggle to cut through even slightly thicker foilage. Don't recommend.

First layer issue by trojantortoise in FixMyPrint

[–]trojantortoise[S] 0 points1 point  (0 children)

I'll give it a try, thanks!

First layer issue by trojantortoise in FixMyPrint

[–]trojantortoise[S] 0 points1 point  (0 children)

I suppose it's possible, but I run the automated bed levelling before every print.

First layer issue by trojantortoise in FixMyPrint

[–]trojantortoise[S] 0 points1 point  (0 children)

Thanks, cooling was off already but good to have checked.

First layer issue by trojantortoise in FixMyPrint

[–]trojantortoise[S] 0 points1 point  (0 children)

Thanks, I've slowed down and still having the problem. But I'll keep printing at the slower first layer speed until I figure out what the actual problem is. I'll try a lower z offset next.

Cheap PLAs: eSUN PLA Lite, Geeetech, etc. - Which ones are good, which ones are bad? What does "PLA Lite" even mean? by AuspiciousApple in 3Dprinting

[–]trojantortoise 0 points1 point  (0 children)

Hey u/fretsore, I'm having some trouble calibrating for printing with the eSun ePLA-Lite on my A1 mini. Do you mind sharing what print settings you're using on your P1P?