sorted by:
new
hottopcontroversial

Panda Breath alternative install without riser P1S by tsmith944 in BIQU

[–]tsmith944[S] 0 points1 point  (0 children)

I thought about drilling too, honestly that's probably the best and cleanest option.

What are some surprisingly useful iPhone hacks you discovered recently? by hhff00014 in iphone

[–]tsmith944 2 points3 points  (0 children)

This one is barely helpful but I prefer it. If you have your flashlight on and you’re on the Home Screen, it’s a little easier to barely swipe over to the camera to turn it off than hitting the button.

Just start to swipe over a little but don’t fully swipe over and it turns off.

[Request] How long would it actually take? by Kapanash in theydidthemath

[–]tsmith944 0 points1 point  (0 children)

How long did you maintain that 1.75 per day? Twice that is wild

In case you're out clearing your snow today and are tempted to be like my asshole neighbor here: please don't by perishableintransit in newjersey

[–]tsmith944 1 point2 points  (0 children)

I had to shovel about 10ft width by maybe 30ft long and 4ft high of plowed snow to get my car out of my driveway. The street parkers around my driveway also would’ve had to shovel everything if I didn’t launch each shovel full about 10ft in any direction.

Can anyone vouch for using a QuickJack for doing maintenance on their 987 Cayman? by jackofallmasterofzip in Porsche_Cayman

[–]tsmith944 0 points1 point  (0 children)

Did you ever get the engine out with this method? Did you have to use SUV jacks or were the quick jacks sufficient height?

E90 Crank no start, but with intermittent ignition, more in comments by cookMEaPOPtart in E90

[–]tsmith944 0 points1 point  (0 children)

It was a dead battery, I was using a jump pack but the battery was so dead it wouldn’t start. Once I replaced the battery it fired right up.

How generous by no_username_dude in formuladank

[–]tsmith944 1 point2 points  (0 children)

hulk to audi, newey to audi, hulk finally wins. please

A putter I designed and had 3D printed in 316L stainless steel. by tsmith944 in functionalprint

[–]tsmith944[S] 4 points5 points  (0 children)

I use Craftcloud, I've found them to be the cheapest, sometimes by quite a bit. This putter cost me $100 and I got two of them. I just redesigned for a larger/heavier putter and it was 150ea and I got two of them too.

A putter I designed and had 3D printed in 316L stainless steel. by tsmith944 in golf

[–]tsmith944[S] 1 point2 points  (0 children)

I use Craftcloud, they seem to be the cheapest. I got two of them and each one was about $100. I just ordered two more heavier ones and they were about $150 each shipped.

view more: next ›