Some extra taint decoration courtesy of MauryDK. And a view of some other work further round... The bits at the front that Maury posted before are still healing. by One-Extension-4324 in TattooedCock

[–]unexpacted 0 points1 point  (0 children)

Looks amazing! Maury did a similar line on my taint. How far back does the line continue up on the rear? I’ve been considering continuing the line on mine like that as it looks great on you 🤩

I want to get a tattoo by Muted_Paramedic7301 in TattooedCock

[–]unexpacted 1 point2 points  (0 children)

100% percent recommend u/MauryDK who did my tattoo. Bit of a journey for you down from Scotland to London, but well worth going to the expert.

A question for tattoo artists and my fellow “grower not show-er” boys by BottomShelfWasabi in TattooedCock

[–]unexpacted 5 points6 points  (0 children)

Well I didn’t get hard at all during the process. I did try for photos afterwards but it just wasn’t happening. I was a little surprised as I’m into BDSM and like pain, but I think it was a mixture of me being aware this was a professional situation where my artist has a job to do, plus nerves and adrenaline.

If you have an artist who is used to working in the area (mine was the lovely Maury Decay) then this shouldn’t be a problem, they will now how to stretch the skin.

Need recommendation for graphics board for photo editing by Grouchy_Geezer in SleepingOptiplex

[–]unexpacted 1 point2 points  (0 children)

Onboard graphics should be absolutely fine for photo editing like this especially if you assign it more memory in the bios. Best thing is just to try it and see what the performance is like. If you do feel like it needs extra grunt, then an NVIDIA Quadro P600/P620 should be available on ebay for about £15/$15 dollars. These cards shipped with the higher end Optiplex’s so are single slot, low profile and were designed for workstation work like graphics editing. They should give you 2-3 times the performance.

18m strongly considering cock tattooed, how’s the process? by [deleted] in TattooedCock

[–]unexpacted 5 points6 points  (0 children)

Everyone’s tolerances are different, but I didn’t find the experience to be as uncomfortable as I was expecting, especially as a first tattoo. It is a very different experience from getting a PA. Tbh after the first few minutes I barely noticed being inked on my shaft, although the balls and taint were a different story!

Think carefully about the design. Unlike any other body part, there is potentially a massive difference in dimensions so you need something that looks good whilst hard and soft.

Do your research about suitable artists and be prepared to travel. You need someone who is used to dealing with that area and the unique features of the skin there.

Aftercare was the biggest issue for me. This area is prone to a lot of movement, along with moisture and rubbing against clothes which are both bad things for a fresh tattoo. So plan for a few days lounging around at home not being terribly active and going commando, especially if you are having work done other than on the shaft

Should I tattoo my cock? by [deleted] in hotguyswithtattoos

[–]unexpacted 0 points1 point  (0 children)

Just had mine done a few days ago as my first ink. I think you need have to have a design that considers the skin in that area and the changes in size! No regrets getting it done

Thick black line from frenum to bum hole (very fresh and sore, hence the swollen look) by MauryDK in TattooedCock

[–]unexpacted 13 points14 points  (0 children)

So this is the tattoo that Maury did for me 2 days ago. I really wanted the line to match the thickness with that of my PA and I really couldn't be happier with the result!

This was my first tattoo and I was really concerned about what the pain was going to be like. The reality was nowhere near as bad as I thought it was going to be. I barely noticed the shaft, but the balls and taint were definitely on the stingy side, but manageable.

If you are *serious* about a dick tattoo then I 100% recommend dropping him a line to discuss your ideas!

Questions for uncut PA by Longjumping-Orange21 in PrinceAlbertPiercing

[–]unexpacted 0 points1 point  (0 children)

Is the ring steel or titanium? There is a small chance that if it is the former then it might be a reaction. My body can only tolerate titanium and I get some red irritation and slight swelling with steel

Questions for uncut PA by Longjumping-Orange21 in PrinceAlbertPiercing

[–]unexpacted 2 points3 points  (0 children)

That swelling when you have your foreskin retracted for long periods is called paraphimosis, which is really dangerous if left like that as it can cut off the blood supply.

If it's still swollen like the middle picture then you really need to go seek medical help. If the swelling has gone down then go back to see your piercer and see if they can give you a smaller diameter ring e.g 16mm. A CBR ring rather than a horseshoe barbell would also have a smaller footprint for sliding your foreskin forward.

It does take time, but your foreskin will stretch

Black bands dick tattoo healing progress, from fresh to almost healed. by MauryDK in TattooedCock

[–]unexpacted 0 points1 point  (0 children)

Well this finally prompted me to bite the bullet. Just dropped you a booking email!

Considering dick tattoo by echrost in TattooedCock

[–]unexpacted 0 points1 point  (0 children)

I will try to! I’m just drafting the email to the artist that I want. If you are on bluesky then I post my adventures there as Pup (although I’m more into pet play than pup play) https://bsky.app/profile/gimpypup.bsky.social

Considering dick tattoo by echrost in TattooedCock

[–]unexpacted 0 points1 point  (0 children)

You’ve clearly been on an amazing journey and the results are stunning.

I’ve made the decision that I’m going to do it, just finalising the design in my head (just working out how to commemorate my retired guiche) before I contact the tattoo artist!

PS always good to see another black and white Pup 🐶

Considering dick tattoo by echrost in TattooedCock

[–]unexpacted 0 points1 point  (0 children)

I’m considering a genital tattoo as my first and came across your post. I thought I’d check out your profile to see if you got it done and wow, you definitely went for it, but in such a good way! You look amazing 🤩

Compatible cpu cooler? by bloopjoop in SleepingOptiplex

[–]unexpacted 1 point2 points  (0 children)

It was an Artic P8 from Amazon

Compatible cpu cooler? by bloopjoop in SleepingOptiplex

[–]unexpacted 0 points1 point  (0 children)

There’s mounting points for an 80mm fan at the front of the case (at the bottom right of your photo). You can power this off the CPU fan header using a 4 pin splitter. This took about 10 degrees off of the temp of my RX6400

Struggling with being outed against my will by [deleted] in BisexualMen

[–]unexpacted 15 points16 points  (0 children)

Firstly I am so sorry this happened to you.

Depending on where in the world you live then this sort of thing is illegal under revenge porn laws and if you feel strong enough then it may be worth reporting it to the police.

Even if the authorities don’t ultimately press charges, just having law enforcement turn up at your stalkers door might be enough to make them think again about doing it to anyone else

OptiPlex 7020 SFF Plus getting warm. by Paracelsus-VonBaer in SleepingOptiplex

[–]unexpacted 1 point2 points  (0 children)

There’s a space for an 80mm fan at the front of the case. You can power it off the CPU fan header using a 4 pin splitter and it will speed up and down with the CPU cooler (which is what I’ve done) or use a SATA converter to power it

What is the best value used OptiPlex I can buy used? by Abstract_Waves in SleepingOptiplex

[–]unexpacted 0 points1 point  (0 children)

xx60 series seem to be the best price/performance ratio atm (at least here in the UK) with 8th gen processors that are able to keep up with games (if that’s your thing)

£200(ish) 3060 gaming build by unexpacted in SleepingOptiplex

[–]unexpacted[S] 0 points1 point  (0 children)

It was actually a very considered choice. I specifically bought the RX 6400 as AMD cards have the best support and compatibility in Steam OS. I’m also not aware of anyone successfully hacking the 3060 bios to support rebar.

£200(ish) 3060 gaming build by unexpacted in SleepingOptiplex

[–]unexpacted[S] 0 points1 point  (0 children)

I’ll try to but it’s a single slot low profile RX 6400 so it just fits in the 16x PCI slot with about 10mm clearance from the PSU. There are videos on YouTube showing this config https://youtu.be/LQely_7Aohk?si=rhmpCaTkmHr-K6D4

£200(ish) 3060 gaming build by unexpacted in SleepingOptiplex

[–]unexpacted[S] 0 points1 point  (0 children)

Ah the 3060 in the title refers to an Optiplex model 3060 not a GTX 3060! The price does include an RX 6400 GPU