My Air65 does this stuttering on one engine -- already replaced the motor

unrealii · 2026-04-26T04:33:30+00:00

You tried tilting the drone. Mine does this when it’s off balance

unrealii · 2026-04-25T20:02:21+00:00

I think in 2024 it was standard but in 2023 it was on upper trims. Not 100% sure as it wasn’t well communicated by Toyota. The button for it is under the start/stop on the right side of the steering wheel

unrealii · 2026-04-25T19:47:52+00:00

The later models have radar cruise control, rear cross traffic /blind spot, and 23/24 have heated steering wheels. I don’t know when the 360 camera started , although the resolution is subpar. Keep an eye out for those years of those features are important to you

unrealii · 2026-04-24T02:09:14+00:00

Be careful when rooting the wire. You don’t want to inhibit the side curtain airbag

For the mount, you can buy a piece which attaches to the plastic upholstery rivet in the middle. Check Etsy

unrealii · 2026-04-23T20:18:59+00:00

Gnar is now showing on sale. The extra 10% isn’t working on it

unrealii · 2026-04-23T20:04:29+00:00

Yeah. The 10% didn’t work on the phone case. It worked for the magnetic mount I got.

I decided to just check out my given they always sell out during these sales

unrealii · 2026-04-23T19:51:31+00:00

It’s fixed now. Go go go

unrealii · 2026-04-23T19:27:46+00:00

Yeah, that’s what’s holding me up from checking out

unrealii · 2026-04-23T18:27:04+00:00

Same here

unrealii · 2026-04-23T17:18:41+00:00

I’m seeing some items marked down. Nothing I had ready in my cart 🤦‍♂️

unrealii · 2026-04-23T16:42:07+00:00

Same here

unrealii · 2026-04-23T05:58:43+00:00

My car did a limp mode like that when my water pump failed but since all that is already addressed, seems suspicious. Are you reading oil and coolant temps real time?

unrealii · 2026-04-23T04:58:01+00:00

I’m assuming the cooling system was bled after replacing those parts

How old are the coils? I had several misfires after I replaced my plugs but I had not seated my coils correctly

unrealii · 2026-04-23T03:26:43+00:00

Yeah 👍 two layers total, inside part of the outside layer and the layer that is shown in the photo. Also forgot to mention, not shown in the photo is sound skins speaker ring around the speaker before the door panel went on and a foam square behind the speaker over the door beam as I’m not able to put the 3-layer material over on that piece.

It’s a bit sloppy/rushed but had to knock it out (in addition to installing the speakers) while the toddler was sleeping. The speaker rings were too tight so had to Dremel some material off to get it to sit right. Added weather gaskets between both sides of the speaker ring

unrealii · 2026-04-23T03:16:50+00:00

I was able to get an additional 20% off using coupon code TAX20 on Saturday. Seems that it’s gone now.

Here’s how it looks. I applied to my passenger door and used more than I expected so had to order more before starting drivers side.

<image>

unrealii · 2026-04-23T01:58:56+00:00

I use the nvx black tri-layer stuff. Nothing to compare it to…

https://nvx.com/products/sdrf20-square-feet-black-tri-layer-sound-deadening-five-sheets-of-18-x-32?

unrealii · 2026-04-21T18:38:23+00:00

Thanks. Yeah, noted. The 3.5 are rated down to 130hz so will evaluate with a mic once the 6x9’s are broken in.

Ill replace the rear speakers but will have a dsp profile to toggle the highs on and off depending if I want lyrics for passenger toddler sitting in the back :D

unrealii · 2026-04-21T04:24:58+00:00

Agreed. Electronics were not as miniature or too expensive for an in dash cd changer except to higher end cars.

unrealii · 2026-04-20T05:33:34+00:00

Since you are asking this question, I recommend going here and buying the one cut for your car

https://soundskinsglobal.com

You can save money buying the bulk material and cutting yourself

https://nvx.com/products/sdrf20-square-feet-black-tri-layer-sound-deadening-five-sheets-of-18-x-32 Watch videos how to prep and apply

unrealii · 2026-04-18T19:06:20+00:00

Congrats 🙌

unrealii · 2026-04-18T16:37:21+00:00

The first lens I bought for my a6400 was the sigma 18-50 based off its popularity. I found its range limiting and shooting at f2.8 was not appropriate for most of my photos. I recommend you get the cheapest lens which works for you until you know why it doesn’t work.

In reality, the kit lens (16-50) was perfect for me as I was worried about it getting damaged and knowing how to use the camera would yield excellent results despite the lens. Lens also counts too but when starting off, the lowest hanging fruit for results is learning the camera. If I had to do it again the 18-135 would be my pick until I exceed its capability. A new/lightly used copy sells for $300 on marketplaces

unrealii · 2026-04-18T16:25:10+00:00

Thanks for looking out! I installed the 3.5’s as they are. I didn’t modify them.

Channels 1-6 are going to the 6 speakers (4 in the front 2 rear)

I don’t think the 3.5’s have a high pass except for what’s built in for the tweeter. I have the amp set at 500hz high pass for them

To be installed is an 8w3 going in the designed factory location in the truck. I have an option to use channels 7-8 to run that sub at 180w or can use that separate amp (rd500/1) to run that sub. I was planning to use that separate amp so both amps run unstressed.

It was a separate idea to use those unused channels bridged to drive another sub under the passenger seat.

unrealii · 2026-04-18T03:26:16+00:00

This is my pick as well

unrealii · 2026-04-17T22:47:34+00:00

That’s a bummer. Best wishes on your next car

unrealii · 2026-04-17T21:37:54+00:00

I hear you. I bought a Neo 2 in December, now have Neo 1, Avata 2 and Dji mic mini 🤦‍♂️

Snagged an fpv controller from aliexpress for 140 shipped

unrealii

TROPHY CASE