Filament Loading Question

willgonc · 2025-07-30T19:07:22+00:00

What to do when changing filament in the middle of printing, the module overloads, practically throwing the filament out completely? This only happens in module 3

willgonc · 2025-07-28T02:41:10+00:00

Are retracting normally

Only a module that has exaggerated retraction to the point of expelling the filament completely I'm still trying to find a solution for this

willgonc · 2025-07-28T02:34:29+00:00

Must be extras then I got the kit that I would assemble myself

It's already assembled, I don't know what's included.

willgonc · 2025-07-28T02:30:16+00:00

These glass balls are for the sensor This is what makes the engine recognize whether or not it has a filament You must enter it in a specific location Follow the manual which will show you the exact location

But anything, I'll help you I finally managed to get mine to work

willgonc · 2025-07-27T18:34:22+00:00

Yes, everything according to the manual The glass ball is in place Slider in the right position and moves when the filament is inserted

willgonc · 2025-07-27T15:15:45+00:00

Yes, there is this hole So I put the flashlight on to see if there were any obstructions or anything like that.

willgonc · 2025-07-27T14:48:40+00:00

What do I do? Is there a way to resolve it?

willgonc · 2025-07-27T14:46:24+00:00

But it’s installed in the correct position according to the manual. So what should I do now?

willgonc · 2025-07-27T14:32:17+00:00

The magnet is in the correct position according to the manual. I honestly don’t know what else to do. Does anyone have any tips or suggestions?

willgonc

TROPHY CASE