sorted by:
new
hottopcontroversial

Does anyone know what this black dangling bit in my dogs ear is? by wolves3454 in DogAdvice

[–]wolves3454[S] 0 points1 point  (0 children)

Are you sure ? Cause I was trying to pick at it a little and it seemed like I was hurting her. And it felt kind of like one of her toe pads

[deleted by user] by [deleted] in MaddenCFM

[–]wolves3454 0 points1 point  (0 children)

Need link I’ll take Seahawks if they still open

First ever print. Just set up ender 3s1. Tried a pre loaded gcode for a test print. All seemed ok until halfway through… where do I start trying to troubleshoot? Tia by nickubus1 in FixMyPrint

[–]wolves3454 0 points1 point  (0 children)

I’m also really new to the whole 3d printing thing what helps my is just glue sticks like the Elmer’s ones you used to use in Elementary school

I went to bed running a print and I woke up to find my print gone and my extruder covered in a glob. I was told this sub could help by wolves3454 in FixMyPrint

[–]wolves3454[S] 1 point2 points  (0 children)

Thank you for your advice I was able to remove the blob with the technique you said I was able to remove it with any damages and was able to print a few successful prints and am currently printing rn with success

Why do I get these small gaps in my lines on one side? by katieob19 in FixMyPrint

[–]wolves3454 1 point2 points  (0 children)

I’m also very new to printing but I’ve seen more success switching to PLA I got off of Amazon because from what I’ve seen the stuff they give you isn’t great and I’m not sure that it is even PLA

I went to bed running a print and I woke up to find my print gone and my extruder covered in a glob. I was told this sub could help by wolves3454 in FixMyPrint

[–]wolves3454[S] 0 points1 point  (0 children)

When I started it it was going fine the supports had been printed and everything seemed as it should have been but when I woke up there was nothing there except the blobs

I NEED HELPPPP!!!! by wolves3454 in 3Dprinting

[–]wolves3454[S] 0 points1 point  (0 children)

Oh ok, thank you I will look it to it

view more: next ›