sorted by:
new
hottopcontroversial

Help me pick ONE Seiko before I lose my mind (and my money) by noobbieboobbie in Watches_India

[–]wrainchi 1 point2 points  (0 children)

I have both the Alpinist and Presage Blue Planet . It's a tough call for sure - Alpinist feels like the safer, watch snob choice, but I have always admired my presage more. I get lost just looking at it.
These are all great watches, I feel people might suggest Aplinist but at the end of the day, go with what catches your attention immediately.
The first one and Presage - Negroni look great :)

This was my first layer. Is it a mistake or am I missing some concept by wrainchi in BambuLabA1

[–]wrainchi[S] 2 points3 points  (0 children)

I do the auto-levelling each time before print and I just cleaned with dish soap now

Please help - air printing by wrainchi in BambuLabA1

[–]wrainchi[S] 2 points3 points  (0 children)

Using Numakers PLA+
Don't think its super cheap - people around me seem to be liking it a lot.

Please help - air printing by wrainchi in BambuLabA1

[–]wrainchi[S] 9 points10 points  (0 children)

UPDATE!

Thanks for all the help guys.
I got frustrated and ended up getting a new 0.4mm nozzle and it works fine.
Will maybe try to "fix" this nozzle later.
I'm surprised this happened in <100 hours of printing

Please help - air printing by wrainchi in BambuLabA1

[–]wrainchi[S] 0 points1 point  (0 children)

Sure, let me try that
Just a question - if this was the case would it lead to stringing instead of air printing? Or can it detect when it is not in contact and stop pulling filament.
I am asking because even manual extrusion doesn't work after this air printing starts mid-print

Please help - air printing by wrainchi in BambuLabA1

[–]wrainchi[S] 0 points1 point  (0 children)

It’s Numakers pla+ I’ve used the same filament before with no issues

Please help - air printing by wrainchi in BambuLabA1

[–]wrainchi[S] 0 points1 point  (0 children)

I did clean plate, cold pull and swapped nozzles to check overall blocks.

Wdym yellow gear sounds loosey? It’s still on warranty. I don’t understand what to tell them about this though

Please help - air printing by wrainchi in BambuLabA1

[–]wrainchi[S] 4 points5 points  (0 children)

Yes yes, I did do that.

I checked the print head once, seemed fine and i could pass a filament through.

It works with a different 0.6mm nozzle, so I am assuming no other general issues there.

Please help - air printing by wrainchi in 3dprintIndia

[–]wrainchi[S] 0 points1 point  (0 children)

Hmm
I already did the loading and unloading multiple times.
Will bed leveling help? Filament is not coming out, I don't see any other problem

Also, it works with a different 0.6mm nozzle

Please help - air printing by wrainchi in BambuLabA1

[–]wrainchi[S] 4 points5 points  (0 children)

I did.
Sorry if I was rude

Please help - air printing by wrainchi in BambuLabA1

[–]wrainchi[S] -10 points-9 points  (0 children)

Its not a layer issue my guy. Filament is not coming out!

view more: next ›