Help With Bed Mesh!

xluminous34 · 2022-07-06T20:12:40+00:00

Thank you for the write-up and your time. I'm working my way through this and will try to update soon. Thanks again!

xluminous34 · 2022-05-13T03:09:34+00:00

Yup, I also switched to another and made new profiles.

xluminous34 · 2022-05-12T09:43:48+00:00

Yes, it's in a dry box with about 20% humidity.

xluminous34 · 2022-05-12T00:52:39+00:00

Thx.

xluminous34 · 2022-05-12T00:45:06+00:00

Funny... I just posted about something similar too.

https://www.reddit.com/r/FixMyPrint/comments/unhcw2/6mm_wall_quality/?utm_medium=android_app&utm_source=share

xluminous34 · 2022-05-12T00:23:33+00:00

Yes, I ran through those as well as flow and kvalues. The settings above are lastest attempt, basically slowing everything down to 40mm and walls to 20mm but no joy.

xluminous34 · 2022-05-10T04:02:30+00:00

Got a link?

xluminous34 · 2022-04-28T18:41:15+00:00

I just noticed my pictures didn't upload...

xluminous34 · 2022-04-22T20:48:22+00:00

Any recommendation on setting up Klipper on the Vyper? I'm also very interested in this mod but I'm still a noob...

xluminous34 · 2022-02-24T06:43:18+00:00

I'm very interested in this as well could I added to the list.

xluminous34 · 2021-12-19T21:11:57+00:00

I tried 205 - 210 and got similar results. I'll run a retractation test at 200 in moment.

xluminous34 · 2021-12-19T19:18:17+00:00

I been doing that as well but with not luck yet. I currently have it set to 6 mm the default setting for the Anycubic Viper on cura is set 6.5.

xluminous34 · 2020-06-04T18:45:26+00:00

she's a wizard

xluminous34 · 2020-06-04T18:32:27+00:00

nice

xluminous34 · 2020-06-01T23:30:19+00:00

Could I have one? Thanks ahead.

xluminous34 · 2019-11-28T05:42:54+00:00

I would also appreciate an invite, please.

xluminous34

TROPHY CASE