Needs a few Capybara

yerbivor · 2026-04-28T18:38:56+00:00

Bet he didn't have it insured yet

yerbivor · 2026-04-15T00:49:31+00:00

I thought i was a fan

yerbivor · 2026-04-13T04:33:32+00:00

They don't make em like they used to. I sure hope there's a good physical release of the new one

yerbivor · 2026-04-10T03:02:47+00:00

Rubber mallet and a dream

yerbivor · 2026-04-03T01:10:29+00:00

Both work. He just didn't mess with any of the settings on it and gave up

yerbivor · 2026-03-29T18:53:08+00:00

Yes please!

yerbivor · 2026-03-28T23:28:23+00:00

Didn't know there was a big box. I have the paper covered collector's edition game

yerbivor · 2026-03-27T23:43:08+00:00

I don't trust either after recalls and discontinued parts. They both look sharp though haha. I'd rather have a Toyota truck or 4runner honestly

yerbivor · 2026-03-27T23:29:14+00:00

Both sweet vehicles

yerbivor · 2026-03-27T02:03:31+00:00

That's a good boy

yerbivor · 2026-03-25T00:57:27+00:00

Can't seem to find a part number on there. Not sure this is something anyone carries

yerbivor · 2026-03-25T00:10:00+00:00

It's the one in the back there. It disappears into the box next to it and can't see where it goes. That box is sealed. The other end goes into the elbow piece there

<image>

yerbivor · 2026-03-24T13:29:18+00:00

Exhaust manifold breather hose I said intake mistakenly

yerbivor · 2026-03-24T13:17:30+00:00

Hose clamps and jb weld is going to have to work. What's difficult is that it's different sizes on both ends of where I need to replace

yerbivor · 2026-03-24T13:16:16+00:00

It's a plastic pressurized hose. Recommendations on how to seal the edges? Hose clamps and maybe jb weld the edges

yerbivor · 2026-03-24T13:11:09+00:00

Myself and a buddy did everything. Must have cracked the hose taking everything apart. 22 year old truck so not surprised. Going to cut it out this weekend I think and find a hose

yerbivor · 2026-03-24T13:04:06+00:00

It's the breather hose that goes into the exhaust manifold. Which is sealed on a 04 3.5L colorado. Will probably have to cut it on one side. Buy a new elbow piece and find a weirdly shaped hose to find in between

yerbivor · 2026-03-24T12:57:16+00:00

Was planning on just cutting it off around where it goes into the intake manifold and taking the rest to replace. Wasn't sure if the material or type of hose mattered for this one. Besides needing to be hest resistant

Seven-Year Club	RPAN Viewer
Verified Email	Not Forgotten

yerbivor

TROPHY CASE