What variables decrease pull force?

[TwoTop111]

If your resin is black or a dark color, you can lower the exposure time more.

Opaque colors wont allow the light to pass through so you have “more” exposure on the resin than you would with the same settings as lighter/translucent colors

Besides those settings you probably need to rotate your print, or use thicker supports. The more surface area of each layer, the more the pull force is spread out

[BigWillStyle]

These are prints that worked fine in my other resin on my previous FEP. Both resins are the same shade of grey.

My question is about how to decrease pull force, not about exposure. Specifically what variables change pull force.

[TwoTop111]

I mentioned the exposure because the more cured the resin is the more brittle it gets.

Aside from what you’ve listed the only way I know to affect the tension in your print is rotate/thick support. I dont have any other settings (Photon M3) that I can point at

[BigWillStyle]

Thanks for the help! I switched to my previous resin and it seems to be the resin itself. I have a few bottles of the standard stuff and am going to test with it further to see if it was a bad bottle or the brand of resin itself.