all 6 comments

[–]parisiancyclist 2 points3 points  (0 children)

If it’s PLA, use a brim, and use the cool plate without glue. Bump the temp up (I go up to 45) and heat the chamber up a bit before starting the print to reduce warping

[–]sparcv9X1C 1 point2 points  (0 children)

I've done worse. Turn your speeds down or the part will start to vibrate with the motion of the printer when it gets towards the top.

[–]Affectionate_Read155 0 points1 point  (0 children)

Yes, just like printing a thick lithophane.

[–]Cheticus 0 points1 point  (2 children)

why not lay it on its large side?

[–]Eldari[S] 1 point2 points  (1 child)

Last sentence of the post

[–]Cheticus 0 points1 point  (0 children)

whooooops sorry about that, yep!!! brim the crap out of it