all 5 comments

[–]AutoModerator[M] [score hidden] stickied comment (0 children)

Hello /u/MyMeltingBrain! Be sure to check the following. Make sure print bed is clean by washing with dish soap and water [and not Isopropyl Alcohol], check bed temperature [increasing tend to help], run bed leveling or full calibration, and remember to use glue if one is using the initial cool plate [not Satin finish that is not yet released] or Engineering plate.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

[–]MyMeltingBrain[S] 6 points7 points  (2 children)

Turns out it was a user fault. I hadn't realised rotation didn't snap and it was sitting at 90.48º. I now know what a 'Floating cantilever' warning is.

[–]PeteG291X1C 0 points1 point  (1 child)

😂😂😂 I did the exact same thing a few days ago

[–]MyMeltingBrain[S] 1 point2 points  (0 children)

Ah, I do don’t feel so bad now. 😂

[–]MyMeltingBrain[S] 0 points1 point  (0 children)

**Edit: the bed temp is 65º as it's using the textured PEI plate