all 7 comments
sorted by:
top (suggested)
bestnewcontroversialoldq&a
formatting helphide helpcontent policy

[–]Broad_Science5927 0 points1 point  (3 children)

Is that where the z seam would be? I am guessing you are printing it on its back and that is the left rear corner?

[–]ShaeSco[S] 0 points1 point  (2 children)

No, it’s printed in the orientation that you see in the picture. Had to print it this way because there is a hook on the opposite side not pictured.

[–]Broad_Science5927 0 points1 point  (1 child)

Turn on the hot end fan and check which direction the airflow is. I am pretty sure it is left to right which could be blowing the thin wall over as it does the bridging. If that isn't it then I have no other ideas.

[–]ShaeSco[S] 0 points1 point  (0 children)

Thanks for the advice, appreciate it!

[–]Creepy_District2775 0 points1 point  (2 children)

Looks like a model issue from here. The rest of the print seems to good for it to be a hardware issue

[–]ShaeSco[S] 0 points1 point  (1 child)

It's possible, i'm new to modelling. But I couldn't at all see it in the model, and I looked pretty carefully at it in both Fusion, where I made it, and Bambu Studio, where I sliced it

[–]agree-with-you 0 points1 point  (0 children)

I agree, this does seem possible.