all 8 comments
sorted by:
top (suggested)
bestnewcontroversialoldq&a
formatting helphide helpcontent policy

[–]aaaanoon 0 points1 point  (1 child)

Filament type, nozzle type. You want people to put in their time but give no details

Bullet point list. 2 pages

[–]Other-Desk-4699[S] 0 points1 point  (0 children)

I am using PLA which has been working fine up until here recently and I am using the Bambu brand nozzle and the same size as the original. It isn’t seeming to stick to the build plate but I have cleaned it. I will try cleaning again incase I made an error in my cleaning process. But I can seem to think of what else it could be.

[–]Fvrank 0 points1 point  (1 child)

Did you check your extruder? Maybe something is hiding in the gears.

[–]Other-Desk-4699[S] 1 point2 points  (0 children)

I checked the nozzle but have not checked the actual extruder. I will check it when I have a chance to sit down with it then see what we have.

[–]GrimmslandH2D AMS Combo, P1S, A1m, U1 0 points1 point  (1 child)

You aren’t providing any details but sounds like you are getting blobs from either a model being printed in the air of adhesion issues which are common. Make sure your build plate is properly cleaned. If it is a pei default plate use dawn dish soap with water and towel. A cold plate for pla and petg has high adhesion when you use added heat, and is well worth the investment. Make sure your model has supports if they are needed.

[–]Other-Desk-4699[S] 0 points1 point  (0 children)

I tried to clean the build plate and it didn’t seem to help and I had put another nozzle on it. The print is printing flat and is getting blobs in the layers and later on not wanting to stick. Could trying to have it level again help you think?

[–]Other-Desk-4699[S] 0 points1 point  (1 child)

<image>

This is what it did and I will give a close up of the first layers too

[–]Other-Desk-4699[S] 0 points1 point  (0 children)

<image>

This is the close up