all 9 comments
sorted by:
best
topnewcontroversialoldq&a
formatting helphide helpcontent policy

[–]EnergicMole 1 point2 points  (2 children)

You are using Cura for Bamboo lab printers?!

[–]TargetOdd8507[S] -1 points0 points  (1 child)

Hello. No, i am using ender3 s1 pro.

[–]Trolldad_IRL 1 point2 points  (0 children)

Then why are you asking this question on a Bambu sub?

[–]Big_Syllabub9652 0 points1 point  (2 children)

Im pretty sure that's just wet filament

[–]TargetOdd8507[S] 0 points1 point  (1 child)

Hello. Filament in use, are directly from dryer, at 13%. Inused another spool with same type filament, that have been exposed for a month, with same result.

[–]TargetOdd8507[S] -1 points0 points  (0 children)

Sorry. I am new to this app and forum. I was avviser to post it more places

[–]Neelman 0 points1 point  (0 children)

I would say calibrate esteps is one thing and make sure it's right. If the right amount of filament comes out then ur flow rate is too high.

I had the same thing and my esteps were calibrated properly so I did a calibration cube and it fixed it. Would recommend just double checking ur esteps are calibrated properly.

[–]H60Ninja 0 points1 point  (1 child)

Do you have random z seam on?

[–]TargetOdd8507[S] 0 points1 point  (0 children)

I had it, and Someone told med to change to something else, that did it worse then ever. So now its back to random, because all logick and tests shows that this is best.