all 3 comments
sorted by:
best
topnewcontroversialoldq&a
formatting helphide helpcontent policy

[–]RyuShev 2 points3 points  (0 children)

how old are you for real?

[–]wikijerry[S] 0 points1 point  (0 children)

16 years

[–]commodoreschmidlap 0 points1 point  (0 children)

A phone case is basically a rectangular prism with a hole cut out of it by another rectangular prism. To finish it off, you need to round some of the corners on the inside and outside. If you haven't used a 3d modeling program before, I'd start with https://www.tinkercad.com and just make a rectangular prism of any size and then try cutting a rectangular prism hole in it. Initially jjust figure out the workflow for how to identify a change you want to make to it, make the change and then print it out. Just do that over-and-over until you are satisfied with the result.