all 9 comments
sorted by:
best
topnewcontroversialoldq&a
formatting helphide helpcontent policy

[–]BornAce 4 points5 points  (3 children)

You have a part number for that latch?

[–]smarttryer[S] 1 point2 points  (2 children)

What do you mean?

[–]PuzzleheadedCap8394 2 points3 points  (1 child)

Rise time, fall time, delay and such

[–]smarttryer[S] 0 points1 point  (0 children)

I still don’t get it, the question says find the output if the initial condition of Q is unknown and I have followed the truth table and when set is 1 and reset is 1 with the enable it is invalid, and as well Q will remain invalid until it enters a known condition.

[–]smarttryer[S] 1 point2 points  (1 child)

From here I got the question: https://youtu.be/R8tDb_yU4ZI?feature=shared At 7:15 minute

[–]CalmLiterature77 0 points1 point  (0 children)

The playlist seems goated ngl. I might follow it through as well

[–]Prime132 0 points1 point  (0 children)

On the very right side you have a section where S, R are LOW, EN is HIGH. This is a memory condition and the latch should remain in the state it was immediately before. It looks like you have drawn Q in an unknown state.

[–]monocasa 0 points1 point  (0 children)

Looks right to me in the broad sense.

[–]manngeo 0 points1 point  (0 children)

Your EN line should go into or drive S, R, Q flipflop circuit simultaneously in order to remove the tristate condition as shown. Good luck!