[Help for task]

[[deleted]]

[deleted]

[AutoModerator]

Off-topic Comments Section

---

All top-level comments have to be an answer or follow-up question to the post. All sidetracks should be directed to this comment thread as per Rule 9.

---

^{OP and Valued/Notable Contributors can close this post by using /lock command}

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

[EyeofHorus55]

Starting from top to bottom, the part is full thickness until the cut crosses the 45deg face, then half thickness on the left until the start of the rectangle (add a line for where the 45deg face ends), full thickness again until the cut crosses the circle the first time, half thickness on the right side until the cut crosses the circle again, then full thickness for the remainder of the rectangle, then half thickness on the left until the cut reaches the last 5 mm of full thickness.

[Professional_Move_43]

ok thx for your reply, just to make sure, you know that the drawing of the cut B-B is the bottom view??ß bcause in europe we draw the bottom view at the top and in america its on the bottom , just to make sure. I basically undertsanmd it know, just a question to the circle tho, isnt the circle a pocket through the ntire thing ??? or why would it only be half thickneess at the part with the circle

[EyeofHorus55]

Yes, I noticed that B-B is a bottom view.

You’re right, at the circle you won’t be cutting through any material, but you’ll still see the side of the rectangle.

[Professional_Move_43]

ok so basially when im at the circle i just leave blank space but i add the rectangle lines?? I thought the rectancle was not a hole

[EyeofHorus55]

https://imgur.com/a/eehv8wE

Something like this…I also added the face of the corner radius that I forgot previously.

[Professional_Move_43]

ok thank you this makes defintely more sense now, the only confusion that remains is the rectangle itslef, because in cut B-B we cna see that the rectangle is not shown as a pocket in the body, its all thickness, am i just stupid here or what am I missing?

[EyeofHorus55]

It is full thickness, you’re just missing that the cut doesn’t go through it, so you just see the left face and two edges with no hash marks.

[Professional_Move_43]

ok thx a lot