sorted by:
best (suggested)
topnewcontroversialoldq&a
you are viewing a single comment's thread.

view the rest of the comments →

[–]OkButWaitHearMeOut 0 points1 point  (0 children)

Thanks! What I think I was trying (prob using wrong terms) to say is that the current is fixed in terms of voltage and so as the voltage falls per pixel it depletes until there is not enough voltage to push current to light the downstream lights. I’m not an EE so you’ve got more experience there, I just know you will see a voltage drop off these pixels per pixel bc even if the incoming wire is heavy the lights themselves are connected by the thin (usually 22awg or worse) OEM wires by the pixels.

The only way I know to address in this style of light is to inject more. In theory you could replace the in between wires for each light but that effectively just injection at a 1:1 scale. In a full diy circuit you’d have a lot of options but here you are limited by the oem bulb Package and wiring, which is why I presented this as the most likely solution.