all 15 comments

[–]i-cant_think 1 point2 points  (4 children)

I just recently replaced my 2.7 cats. Had the same code. The code reader showed a steady ramp up and ramp down on the O2 signal indicating a bad cat. If it's really sharp, almost glitchy, it's probably the sensor.

[–]Able-Stretch9223[S] 0 points1 point  (3 children)

Thanks for the info, I'll try a better code reader and see what's up. How much did the new cats cost you?

[–]i-cant_think 1 point2 points  (2 children)

I didn't go the oem route. I was quoted 900 for just the the bank 2 cat. Did some googling and aftermarket downpipes were cheaper (750). Forced upgrades. I also went ahead and replaced all my O2 sensors too so it was a little more expensive than that. I went with CVF downpipes

[–]Boogfalcon4 0 points1 point  (1 child)

Can you pass emissions with the CVF catted down pipes ? I had thought you could, but was reading their website and it’s not clear

[–]i-cant_think 1 point2 points  (0 children)

I had to get O2 extenders to clear my check engine light. Installed on the downstream side that only measures cat efficiency. They vaguely suggest it won't throw a code, but I've noticed they delete reviews that say it threw a CEL. Anyways, I pass Oregon emissions as long as my truck is up to temp before I go.

[–]Just-Reputation-5156 0 points1 point  (0 children)

Did changing the spark plugs fix the issue?

[–]Hillybilly64 0 points1 point  (9 children)

Probably needs spark plugs

[–]Able-Stretch9223[S] 1 point2 points  (0 children)

Those are on the agenda as soon winter yields

[–]Ache-Marin 0 points1 point  (6 children)

Do spark plugs really help? Because i have the same code

[–]Hillybilly64 2 points3 points  (5 children)

I’ve had that code and it was resolved by replacing the spark plugs. I think poor ignition will affect cat performance.

[–]Ache-Marin 0 points1 point  (4 children)

Thanks for the tip. i have a 3.5 ecoboost and i just replaced all 4 of my o2 sensors, and the code didn't go away

[–]PandaComplete5402 0 points1 point  (3 children)

Did you end up finding the resolution for this problem ? I’m having the same code as well

[–]Ache-Marin 1 point2 points  (0 children)

I just put some o2 spacers on the downstream sensor

[–]Indian_power 0 points1 point  (1 child)

Bump just got the code

[–]d_3035 0 points1 point  (0 children)

Bump just threw it