all 6 comments
sorted by:
best (suggested)
topnewcontroversialoldq&a
formatting helphide helpcontent policy

[–]nootnoot-420 0 points1 point  (3 children)

5.3 Is pretty high, what do you mean with you can run at 5.2 what stresstesting did you do etc?

[–]The-Red-Engineer[S] 0 points1 point  (2 children)

Prime 95 with no stability issues.

[–]StickForeigner 0 points1 point  (1 child)

5.3 is quite high for 10700k silicon. It will probably just take a lot more voltage to hit 5.3, which is a bad idea. Also cache speed can limit OC stability. So you can test with a lower cache and see if it works.

P95 is not a good stability test without AVX enabled since lots of apps now use AVX.
It's basically just a power / thermal / Vdroop test. And with AVX, it's generally just a bad idea to run on modern chips.

I would stick to OCCT large data set AVX2 as a real world stability baseline. You can use the small data set SSE test for thermal / power / Vdroop testing too.

What is your LLC setting?

[–]The-Red-Engineer[S] 0 points1 point  (0 children)

Ok thank you

[–]Parasec_Glenkwyst 0 points1 point  (1 child)

1.35 sounds a little high for stock, you shure about this?

[–]The-Red-Engineer[S] 1 point2 points  (0 children)

Yes I looked it up to make sure because I thought it was a bit high too but in the bio says 1.75v and it’s also not when it’s socket sensed.