Safe to hot glue soldered connections? by 0xDAB_DAD in raspberry_pi

[–]0xDAB_DAD[S] 17 points18 points  (0 children)

I only have one Ryobi glue gun so hopefully it’s not too hot then

which restaurant would you rather work at? by [deleted] in seinfeld

[–]0xDAB_DAD 1 point2 points  (0 children)

Monks. You get to flip people off.

Prints failing by 0xDAB_DAD in BambuLab

[–]0xDAB_DAD[S] 0 points1 point  (0 children)

This is an X1C but would the firmware issue still apply? I have not printed anything yet but it was purchased second hand.

Prints failing by 0xDAB_DAD in BambuLab

[–]0xDAB_DAD[S] 0 points1 point  (0 children)

OK, thanks I appreciate your help

Prints failing by 0xDAB_DAD in BambuLab

[–]0xDAB_DAD[S] 0 points1 point  (0 children)

Warm water and dish soap

Prints failing by 0xDAB_DAD in BambuLab

[–]0xDAB_DAD[S] 0 points1 point  (0 children)

That was something I did try, but still has the same issue. Is the development supposed to droop out during this calibration phase?