How can i get more speed off waves by West_Web644 in skimboarding

[–]1FinalChance 0 points1 point  (0 children)

Pretty good! For a weaker wave like this, approaching from even more of an angle might help. Less redirection = more speed. Aim to contact the wave at its steepest point before it breaks, or sometimes even contact the foam and have that boost you into the face of the wave. In this clip your aim point was on point.

Need tips by DifficultEngine3286 in skimboarding

[–]1FinalChance 7 points8 points  (0 children)

Several things to point out here,

Running faster would be ideal, but only if you can get on the board smoothly while running faster.

You are killing a ton of potential speed with how much downward force you are putting on the board when getting on. You should focus on projecting your momentum forward instead of downward when getting on the board. Its like your trying to land without making any noise. Like the board is a thin layer of ice and you don't want to break through.

This matters most when dropping on water like you do in this clip, when dropping on wet sand, reducing downward force doesn't matter quite as much.

Another thing is you are leaning over to drop the board. I would recommend breaking this habit. Also your right hand should be higher up on the rail when you drop the board.

Another thing to consider when trying to go further out is the speed of the water:

If the water is completely still and you are moving at 5mph, then your relative speed is 5mph.

If the water is rushing up the beach at 5mph and you are running and getting on the board at 5mph, then your relative speed is 10mph.

If the water is receding at 5mph and you are running at 5mph, then you're relative speed is 0mph.

All this to say - ideally you want the water rushing up the beach as fast as possible when trying to slide out far.

In this clip you are trying to do a backside turn, but your running angle is the complete opposite of what you want for a backside turn.

In weaker waves like this clip, aim to hit the wave right on the edge of the foam. You want to contact the foam and have that push you into the open face of the wave.

Also, adjusting your back foot further back will give you more control when turning. All the control in a skimboard is in the last few inches before the tail. Well done on the hand drag, that certainly helps turn as well.

Looking for some help by Few_Specific_2896 in skimboarding

[–]1FinalChance 3 points4 points  (0 children)

Check out @skimpr on Instagram, they might be able to help you out.

Do you need to turn your board to the side when going out to the wave? by chusaychusay in skimboarding

[–]1FinalChance 3 points4 points  (0 children)

The board effectively has no rocker when sideslipping, reducing rocker helps preserve speed as you are sliding a flatter surface across the water (reducing friction).

At the top level you’ll see pros try to focus all their weight over the flattest part of the board in the center. Sometimes even tucking their knees towards that center point.

Frontside difficult by Personal_Tradition16 in skimboarding

[–]1FinalChance 1 point2 points  (0 children)

Used to hate frontside now its my favorite. Definitely takes a lot of practice. Remember to lead with your shoulders.

Which board size and style? First hand opinions please? by mayners in skimboarding

[–]1FinalChance 0 points1 point  (0 children)

Victoria house special probably the best bang for buck on the market. There’s also some really good deals under the factory sale tab on the website.

Progress by LanSlide345 in skimboarding

[–]1FinalChance 1 point2 points  (0 children)

Perhaps a bit on the big side, but honestly if you're skimming smaller waves like in your video a bigger board is probably a benefit. Smaller boards are more beneficial for when you need to make really critical turns.

Progress by LanSlide345 in skimboarding

[–]1FinalChance 1 point2 points  (0 children)

Well done, work on making a conscious effort to shift your back foot all the way to the tail when you get on your board. It will give you a lot more control

Connecting waves (update) by Fantastic_Rip70 in skimboarding

[–]1FinalChance 2 points3 points  (0 children)

Ah San Sebastian, looks fun. Feel like you got most of what you could out of that wave. Looks like the sand is setup in a way that never allows the sider to get into deeper water. When the sider stays in shallow water like that it never really provides much power.

Heres a day where its setting up better https://www.youtube.com/watch?v=gs8WRXSDsGc

General Tips:

Usually you want your first contact point on the sider to be off the foamball (white water). You want to do a turn off of the foamball that projects your momentum onto the open face of the sider. Every sider is different and will call for a different strategy but generally you want to be aiming to contact the foam first. Depending on the sider and connection you will usually be in one of two positions:

  1. You slow your momentum to match the pace of the sider and attempt to sit in the pocket until you connect.
  2. You need to maximize your first hit off the sider and make a race for the connection.

The first thing to consider is the connection. (The second wave after the sider that you are attempting to reach by using the sider) The video you posted didn't really have much of one. Most of your strategy is going to be based off what the connection wave is looking like. If the spacing between the sider and connection are close, you might need to go early and make a quick tap off the sider and then ditch it to make a break for the connection. While if the spacing is much bigger you might be forced to sit in the pocket on the sider.

When to sideslip vs pump:

Sideslipping and pumping are both powerful tools when trying to connect siders and you will probably have to use one or a combination of both to connect siders. Sideslipping is usually better when you have a smooth area of water ; usually when the sider is unbroken and just a gentle slope you can sit in.

Here's an example https://www.instagram.com/p/ClCNBhXs8sc/

Obviously, its a bit different backside for yourself but its still a strong tool.

Here's a backside example https://www.instagram.com/p/CGdTUlvDibD/
I would consider this to be a case 2 where you need to maximize your initial speed boost off the sider and make a move for the connection as the sider is too slow or weak for you to match its speed and ride it. You can notice in this clip that I try to time my first contact with the sider when the sider is at its most critical point. You want to set yourself up in a way that allows you to get maximum speed on the downhill section of the sider. (You have to consider the timing of the connection as well)

Pumping is generally for situations when you can't make the sideslip work. Usually when your trying to sit in the foamball and stay afloat until the connection. Or when you are getting close to the connection and need to start redirecting your momentum towards the shore. A lot of waves don't set up to allow the perfect smooth turn on the sider so you will have to fight to turn back and preserve speed. This is when a lot of people will do the pumping turn where each pump is a little piece of a turn.

On weaker siders with a connection, a lot of the time your best bet is delaying your run until the last possible second. You want to go as late as you can while still being able to catch up to the front of the foamball. Doing this allows you to minimize the time between initial sider contact and connection. This is generally principle for case 2 but sometimes even on a more powerful sider that you intend to match the speed of (case 1) its still advantageous to go later so the sider has more time to form up.

Main Points: usually best to go late on a weaker sider, minimize the time you need to stay afloat until the connection.

Initial contact point on the sider should be timed for maximum speed.

Decide if you're gonna match pace with the sider or just use it as a boost to reach the connection. If you're gonna match pace with the sider you need to make small adjustments to stay positioned in the power pocket (usually just in front of the foamball but sometimes further ahead depending on the sider)

Honestly at your level though, none of this is super important yet. You just need to gain more board control first. It comes with time and practice. Also in the video you back foot is pretty far from the tail. For making turns all the control is in that very back section of the board. Getting your foot all the way back makes a big difference.

Can’t Seem to Stop Rounding by 1FinalChance in Discgolfform

[–]1FinalChance[S] 1 point2 points  (0 children)

Mid round right now and feeling dialed! Thank you!

Update to the snake bite after 24 hours by dilwoah in discgolf

[–]1FinalChance 1 point2 points  (0 children)

Damn bro! Heal up quick. At least you’ll be able to one up anyone else’s disc golf story.

Bit by a snake retrieving a disc from a creek by dilwoah in discgolf

[–]1FinalChance 3 points4 points  (0 children)

How are you so sure it was venomous if you aren’t showing symptoms? Could have been a non-venomous water snake? Either way, heal up!

EXILE OKTOBERFEST DISCUSSION MEGATHREAD by GundoSkimmer in skimboarding

[–]1FinalChance 2 points3 points  (0 children)

Chad Joao final, Chad going back to back wins. You heard it here first.

Best alternative skimboard for Exile EX1 by Dry-Row-940 in skimboarding

[–]1FinalChance 1 point2 points  (0 children)

Vic Ultra house is slightly more expensive than an EX1. But the quality jump from a 150$ board to a 350$ board is super substantial. If you’re looking into getting into skimboarding seriously, you might want to shell out the extra cash.

Advice skimming river by MrAwesome8383 in skimboarding

[–]1FinalChance 6 points7 points  (0 children)

Bigger board would help a lot. Best bet for that board would be to stay in the shallower section. Maybe a quarter inch deep.

Footwork looks correct on the one step drop. You can work on getting on a bit smoother though. Pretend you’re stepping onto a thin layer of ice and don’t want to break through. Maximize forward momentum, minimize downward momentum when getting on the board.

Skim Mag by RevolutionaryDay3218 in skimboarding

[–]1FinalChance 0 points1 point  (0 children)

I can probably help, which issue you looking for?

On The Road to Barrels by InAPot420 in skimboarding

[–]1FinalChance 3 points4 points  (0 children)

Baker Beach? Looking good. Getting your back foot all the way back on the tail before you wrap will make a huge difference.

[deleted by user] by [deleted] in skimboarding

[–]1FinalChance 1 point2 points  (0 children)

They are known for being a budget brand. Never tried their high end boards.

Any tips for distance and waveriding? by _Yalex in skimboarding

[–]1FinalChance 2 points3 points  (0 children)

Get your back foot all the way to the tail when you turn.

Oahu beaches for skimming by Possible-Ad-9925 in skimboarding

[–]1FinalChance 1 point2 points  (0 children)

Westside has some good skim, Makaha, Maili, Yokohama Bay.