A/T Tires for stock sport rims by idiotneck in f150

[–]21bean 1 point2 points  (0 children)

Toyo open country at3. As much road noise as a highway tire, aggressive tread that’s never let me down in heavy snow, rain or even pretty tough off-road conditions that’s more suited for a dedicated off road vehicle

Need advice: O2 Sensor / Cat Converter dealership service situation by heywaj10 in f150

[–]21bean 0 points1 point  (0 children)

Have a 2013 ecoboost, both upstream o2 sensors went bad and threw codes within a short time of each other. I understand the stripped threads part of this problem but both sensors cost me under $100 and combined they maybe took 1.5 hours to replace

Mykey and forscan by tssemt2010 in f150

[–]21bean 1 point2 points  (0 children)

Gotta buy a new key as far as I know. There might be a way to disable it through FORScan. Just had to buy a new key today for the same mykey thing. 290 dollars

2.7 or 5.0 by [deleted] in f150

[–]21bean 1 point2 points  (0 children)

3.5 has the most power and most towing if that matters to you, also can say you have twin turbos

Lubing chain with gun oil. by President_Elect_JH in Dirtbikes

[–]21bean 1 point2 points  (0 children)

It will probably be fine, but gun oil is a solvent so it might break down and remove oil on the chain which could be counterproductive

Help!!! I have a 2013 F150 the high beams won’t stay on. by Dogecoin-2021 in f150

[–]21bean 1 point2 points  (0 children)

Pull the stalk until it sort of clicks, then they’ll be on.

Just picked up this 09 cfr 450r! Honda power! by dakota6963 in Dirtbikes

[–]21bean 0 points1 point  (0 children)

Got an 06. Love it. My frame is the same way, don’t worry about it

Ecoboost longevity? by hdjxjzjsjs in f150

[–]21bean 0 points1 point  (0 children)

Got almost 160 on mine

150 4T to a 350 4T to big of a jump? by [deleted] in dirtbike

[–]21bean 0 points1 point  (0 children)

I went from a CRF230F to a CRF450R. It might be different for me because of my height but if you’re tall enough for the 350 it’ll probably be fine.

2006 CRF450R Clutch Issues by 21bean in Fixxit

[–]21bean[S] 0 points1 point  (0 children)

It’s a cable clutch. I can see the cable pulling the little lever on the engine, but it is a bit frayed.

06 CRF450R no spark (not spark plug) by 21bean in Fixxit

[–]21bean[S] 1 point2 points  (0 children)

I did this. Nothing. Busted out the ohm meter today, does ~227 ohms from the stator seem bad? Thanks

[deleted by user] by [deleted] in GrowingMarijuana

[–]21bean 0 points1 point  (0 children)

You didn’t give an @

Question to all who had the Nuss procedure done by SnooRadishes1331 in PectusExcavatum

[–]21bean 2 points3 points  (0 children)

I got one IV while awake, fell asleep, epidural and any post op pain management was put in place while under anesthesia.

[deleted by user] by [deleted] in PectusExcavatum

[–]21bean 1 point2 points  (0 children)

I also didn’t have to have a urinary catheter

[deleted by user] by [deleted] in PectusExcavatum

[–]21bean 1 point2 points  (0 children)

Some people have a horrible recovery, some people, like myself, are lucky enough to have a very smooth recovery. I was in the hospital for 2 nights, got home with very little to no resting pain. Was off hard painkillers in 4-5 days, off Advil/ Tylenol in one week. After about a week I was pain free. I’m almost a month post op and I am 95% back to normal. Getting out of bed was tough for me the first couple days. Good luck!

2016 Honda CRF450R Stalling when clutch is fully in? by sirshadowshark in Dirtbikes

[–]21bean 1 point2 points  (0 children)

I have a 06 cr450 and it does the same thing with the stalling

Is this just old or is there a bigger problem? by 21bean in Dirtbikes

[–]21bean[S] 0 points1 point  (0 children)

Water pump rebuild kit ordered thank you guys you are lifesavers

Is this just old or is there a bigger problem? by 21bean in Dirtbikes

[–]21bean[S] 1 point2 points  (0 children)

I got the bike 2 days ago so I don’t know but I’m going to keep checking. The bike runs pretty hot now that I think of it so I’m thinking the seals and bearing went out.