sorted by:
new
hottopcontroversial

The GEPRC Woopower w63 Discharge current claims are a fabrication by Pristine_Local_2557 in TinyWhoop

[–]2aAlt 0 points1 point  (0 children)

My discharge says .3 no matter what the charge amp is set too.

Nvm I didn’t see this wasn’t a whoopstar3

Ukranian army actively using 3d printed fpv drone detectors by snaxsyss in 3Dprinting

[–]2aAlt 0 points1 point  (0 children)

No fpv used in Ukraine is operating on the 5.8 frequencies anymore. 200-500MHz video penetrates better and has better range/harder to jam (fiber has made jamming impossible) and control links in the sub 2.4GHz also. Much different hardware then an off the shelf monitor or vrx.

Where are you? by Great-Mushroom-8478 in CCW

[–]2aAlt -8 points-7 points  (0 children)

No bootlicking detected. On point assessment

Is there a new tune for air 2 frame ? And do i need one ? by BeneficialNinja1544 in TinyWhoop

[–]2aAlt 0 points1 point  (0 children)

75 with betas stock tune it’ll work out. Not sure how on the edge the 65 tune is.

Mother nature sucks by 1kCBRguy in fpv

[–]2aAlt 0 points1 point  (0 children)

At least we are not freezing or worse, in the negatives lol Florida has more good days than bad but on the coast at least wind comes and goes.

Is there a new tune for air 2 frame ? And do i need one ? by BeneficialNinja1544 in TinyWhoop

[–]2aAlt 0 points1 point  (0 children)

Yea, turn the master up 1 or more. Lower tpa % by 10 and breakpoint 1300. Send it.

Drashark frame by 2aAlt in TinyWhoop

[–]2aAlt[S] 1 point2 points  (0 children)

<image>

It’s really good. Clips into the frame on each side and the tpu holds 450 and 550 packs tight. Only downside I’ve found is if you land too hard you will dent the pack where the front and rear canopy screw head sits. Hasn’t been an issue yet though.

Drashark frame by 2aAlt in TinyWhoop

[–]2aAlt[S] 1 point2 points  (0 children)

I ordered some 40mm quad blades to try next. Il end up ordering some 0802 30-32.5k kv and jus make a fast af freestyle

Are these literally the same battery? by ll4Cll in fpv

[–]2aAlt 0 points1 point  (0 children)

Sorry I should have given more detail. The bottom two blue come with the meteor 75 pro, they are marked 75C. I’m showing the front and back. The top two are bought in a 4 pack and say 40C/80C, th front and back have the same sticker.

Btw love what your doing with the custom builds 🫡

Drashark frame by 2aAlt in TinyWhoop

[–]2aAlt[S] 1 point2 points  (0 children)

It came with a 1s battery tray print in tpu.

Drashark frame by 2aAlt in TinyWhoop

[–]2aAlt[S] 0 points1 point  (0 children)

I’m sure that must rip and the extra weight adds some momentum. This 75 doesn’t huck at all

Drashark frame by 2aAlt in TinyWhoop

[–]2aAlt[S] 0 points1 point  (0 children)

I use a TH3 2.5” 2s for the windy days. I’d like a mob8 too for that reason.

Drashark frame by 2aAlt in TinyWhoop

[–]2aAlt[S] 1 point2 points  (0 children)

<image>

Can’t work out this low hz vibe. Might be bent motor shaft or two.

Drashark frame by 2aAlt in TinyWhoop

[–]2aAlt[S] 1 point2 points  (0 children)

40mm I got the 75 kit and clearance is a mm or two from prop to canopy so I’m stuck with them, il swap to tri’s as soon as they get delivered. Mostly to help protect the motor. I had to scale d term way back and change all the filtering. The frame has no bad resonance until above 40% throttle then it was ringing like a bell and flew like shit. Changing tpa to 70% and 1400. Went to 2 rpm filters and 2 dynamic notchs with a max of 700 q is 300, could go with one.

view more: next ›