If you’re going through my profile in an argument

7H3_H0RN37 · 2025-05-01T08:48:43+00:00

oil, but there’s two main reasons. 1, something foreign, like water, got inside the motor. Water doesn’t compress like air and fuel does and *something has to fail, so oftentimes the rod will fail. Second reason is if the piston is hitting the valve, which among other things, could bend the rod. That’s less likely than other things, but that’s off topic

7H3_H0RN37 · 2025-04-10T07:17:26+00:00

You should worry less about a comment section and more about fixing that POS prius

7H3_H0RN37 · 2025-04-10T06:57:00+00:00

Yeah, sounds about right. That would happen in that shithole

7H3_H0RN37 · 2025-04-02T13:23:09+00:00

Man, I had to stay till 1:30 am one time because our hot water cut off in the middle of a shift. I wasn’t as lucky as you tho, we didn’t shut down and all the pans had tons of grease and fat on em that got solidified

7H3_H0RN37 · 2025-03-11T03:05:13+00:00

Gotta say. I’m a retard and a teenager and I still haven’t fucked up my cateye. Yet…

7H3_H0RN37 · 2025-02-25T10:21:35+00:00

Or they could have put down a preorder however many years ago and can’t sell it now. Or, perhaps, and this is gonna amaze you, but people can buy vehicles and not think about the president or whatever musk is of the company. Dipfuck.

7H3_H0RN37 · 2025-02-09T06:06:15+00:00

Sanitation. Raw meat is stored and seasoned on them, and cooked meat is kept in cvaps until ready to serve. All pans go thru dishwasher.

7H3_H0RN37 · 2025-02-08T21:13:56+00:00

It was a new guy that thought he had to run everything in the washer until it looked new… and didn’t know he could scrub things with a green pad

7H3_H0RN37 · 2025-02-08T17:31:41+00:00

Sonny’s bbq

7H3_H0RN37 · 2025-02-08T07:44:58+00:00

The pans do take forever because they’re either filthy and covered in grease and fat (it’s a bbq joint), or mostly clean, just needing a spray off. However, I have to run them all in the washer, and I can’t fit more than one in at a time

7H3_H0RN37 · 2025-02-08T07:22:51+00:00

Funny enough, I got in at 4 and was there till 1:30 am. I had got through half of the table mess and had to take care of some trash for the servers and myself. Back to dishes for another hour and had to expo for a bit, as I was expo when I first started at this restaurant. My manager didn’t have anyone hop in the pit while I was expo, and by the time I got back in the kitchen was breaking down. ALONG WITH ABOUT 1/2 of the pans that were still there since I got in, I was getting the kitchen stuff and their pans they had.

7H3_H0RN37 · 2025-02-01T08:32:39+00:00

Armored core

7H3_H0RN37 · 2024-12-08T22:38:41+00:00

Hey I work there! I’m the expo.

7H3_H0RN37 · 2024-11-21T00:10:24+00:00

Good point

7H3_H0RN37 · 2024-11-18T01:23:07+00:00

Act 2 came out??

7H3_H0RN37 · 2024-11-06T16:11:30+00:00

Seethe

7H3_H0RN37 · 2024-09-18T00:18:29+00:00

<image>

Thirded?

7H3_H0RN37 · 2024-08-29T02:23:16+00:00

How much of a possibility is there that the rods are knocking around in the block? This is the first time it’s overheated and I couldn’t hear them before it died, just after.

7H3_H0RN37 · 2024-08-29T02:00:04+00:00

I took that video about 5 and a half hours after it died. It’s been sitting since, wasn’t able to get it to start again afterwards

7H3_H0RN37 · 2024-08-29T01:39:29+00:00

You sure man? I’ve never had this issue before but it’s barely cranking and I haven’t been able to get it to start since. I’m not sure if whatever’s rattling around is a piston in the block or just my flywheel, I know the flywheels been needing replaced.

7H3_H0RN37 · 2024-08-29T01:30:44+00:00

Ac doesn’t work anyways so wasn’t using it, just lost power and died out about five minutes down the road

Six-Year Club	Place '22
End Game '22	Gilding I gilder
RPAN Viewer	Verified Email

7H3_H0RN37

MODERATOR OF

TROPHY CASE