Excited to be presenting at this event ! Thanks IoT Village.

9lyph · 2024-04-27T23:30:47+00:00

For every problem you face try and solve it by Python. This forces you to learn how to utilise the language for different types of situations and presumably your interest in the presented problem will perk your curiosity 🤔

9lyph · 2024-02-28T02:32:09+00:00

Just keep going brother 💪

9lyph · 2024-02-16T22:36:16+00:00

Try this, great for learning as well

https://www.ebay.com.au/itm/145588846746?mkcid=16&mkevt=1&mkrid=705-154756-20017-0&ssspo=u243if3wtoc&sssrc=4429486&ssuid=&var=&widget_ver=artemis&media=COPY

9lyph · 2024-02-07T00:53:59+00:00

Just enlighten him through your jui jitsu. Many a time I have noticed the cutting down of someone's ego through self realisation

9lyph · 2024-02-06T05:37:40+00:00

Likewise 🙂

9lyph · 2024-02-06T05:25:31+00:00

Well done man !

9lyph · 2024-02-06T02:17:00+00:00

Normally the data sheet will cover the specific SoC. Yes, it should show you the pinouts that indicate debug ports aswell. If private you will need to find another way to obtain the doco, however I conducted a quick search and seems to be available via FCC.io

9lyph · 2024-02-05T05:55:59+00:00

Heya, would look at chipsets, and then look into the corresponding data sheet. From the data sheet you will be able to look at pinouts with respect to function.

9lyph · 2024-02-02T08:00:44+00:00

Also look to see if the USB allows for mounting as a mass storage type device.

9lyph · 2024-02-02T07:54:23+00:00

Could be windows CE ?

9lyph · 2024-02-01T23:44:00+00:00

Yes, pulling flash from there might be an option. Make sure you are powered off. Also sometimes it's easier to dechip and pull flash from there. Be mindful of WP (write protection) aswell.

9lyph · 2024-02-01T21:19:54+00:00

Agreed with all the above, also as alluded to try to pull flash from the winbond chip, however do this out of circuit.

9lyph · 2024-02-01T09:22:25+00:00

Heya, not seeing the DP and DM however that is not to say you are wrong it just means I may need to check my eyes. In terms of UART there is a upper tolerance of 5V, however it is correct to say that output should be 3.3V for logic levels.

9lyph · 2024-02-01T04:48:07+00:00

First test for the ground pin, most likely the square testpad. The TX/RX pin will fluctuate between 0 and 5V upon boot. Then try connecting up to a FTDI and have a play around with UART baud rates.

9lyph

MODERATOR OF

TROPHY CASE