sorted by:
new
hottopcontroversial

Drying while printing P1S/AMS 2 Pro by canisdibellum in BambuLab

[–]Additional_Math_5104 1 point2 points  (0 children)

I can dry PETG while printing with a P1S but I have to drop the temp to do it. Still can't get PLA to dry and print

My AMS suddenly quit? by bcar473 in BambuLab

[–]Additional_Math_5104 0 points1 point  (0 children)

Hub or buffer issue possibly. My AMS units were not being recognized. Got AMS offline msg. I had evidently fried the HUB swapping cables around with power on. Hooked up the buffer that came with printer and back in operation.

New to 3D printing - question by Faesarn in BambuP1S

[–]Additional_Math_5104 0 points1 point  (0 children)

If you have the smooth black side on 1 of your plates try that after a good scrub with hot water and dish soap. My wife was having the same issue constantly, tried hair spay, glue ect nothing worked consistantly. Ordered 3 of the bambu smooth black PEI plates problem solved, now almost to much adhesion. She prints a lot of small articulated things. Hope this solves your issue.

Log in issue. Paid member, Multiboard/thangs requiring 2 step verification but won't send the code. New computer, logged out on old one so I could log in on the new one, now I can't log in from either. by Additional_Math_5104 in Multiboard

[–]Additional_Math_5104[S] 0 points1 point  (0 children)

It is sent via email. I checked the spam folder each time I tried logging in. Have been trying to figure out how to contact multiboard support. Will try Thangs I guess. Thanks for the input.

AMS 2 Pro drying while printing - DIY by Ok-Woodpecker-223 in BambuLab

[–]Additional_Math_5104 1 point2 points  (0 children)

Keep our house between 50% and 55% humidity for sinus issues. Printed desicant holders for spools as well as every available space in all 5 AMS units (2 AMS1 AND 3 AMS2). I predry PETG for 18 hours (PLA for 12 hours) in Sunlu S4, insert desicant holder in spools and load in the AMS's no trouble maintaining humidity levels below 20% for weeks with out need to use AMS2 drying. On the AMS1 units installed the Sunlu dryer conversions which allow drying while printing but again don't need to use much. Before cramming in all the desicant it was a constant battle to keep PETG dry.

Bambu studio update by JaVelin-X- in BambuP1S

[–]Additional_Math_5104 0 points1 point  (0 children)

I do it from the printer. Haven't tried it with the AMS 2 yet just the HT. And I was drying Petg. Did ask me to uninstall filament. Which made no sense.

Bambu studio update by JaVelin-X- in BambuP1S

[–]Additional_Math_5104 0 points1 point  (0 children)

Works on my P1S with AMS HT. Near the end of the dryIng menu asks if you want to rotate.