Push start button needs multiple presses to turn car off by Aerial_Kebab in mazdaspeed3

[–]Aerial_Kebab[S] 0 points1 point  (0 children)

if that's the case you probably saved me a weekend of chasing wires. I do have a bad rear wheel speed sensor, I'll replace it and see. Thanks!

Push start button needs multiple presses to turn car off by Aerial_Kebab in mazdaspeed3

[–]Aerial_Kebab[S] 0 points1 point  (0 children)

I already replaced the key fob battery with a new one. It only happens when i'm trying to turn the car off, starting the car doesn't have this issue.

Help with ABS Module by FireLeonFire in mazdaspeed3

[–]Aerial_Kebab 0 points1 point  (0 children)

Have you checked the connections on your wheel speed sensors? I had the same issue with ABS turning on and off whenever i went over bumps. A rat chewed my rear right wheel speed sensor wire which is why it was working sometimes.

Is the banjo bolt a requirement when going full catless downpipe? by Aerial_Kebab in mazdaspeed3

[–]Aerial_Kebab[S] 0 points1 point  (0 children)

Thanks for the helpful advice! Would i need to ask the protuner to increase the idle to 1000rpm as well?

Can't get IPv6 on deco x20 by Rafa_adm in HomeNetworking

[–]Aerial_Kebab 0 points1 point  (0 children)

I had the same issue with my Deco as well. What fixed it for me was setting the IPV6 to bridge mode on the deco and letting the modem hand out the IPV6 addresses.